Bedienungsanleitung Charnwood LA10 (Seite 7 von 16) (Englisch)

815486

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

a) Wet or unseasoned wood, or logs overhanging the front fence will

cause the glass to blacken.

b) The airwash relies on a supply of heated air to keep the glass clean,

therefore, when lighting the stove allow the firebed to become well

established before closing the front air control slider. This may also be

necessary when re-fuelling the stove.

c) When re-fuelling keep the fuel as far back from the front fence as

possible, do not try to fit too much fuel into the firebox.

d) Never completely close the airwash control - as a guide it should

be at least a quarter open.

e) The front air control slider may be kept slightly open to assist in

keeping the glass clean.

It is always more difficult to keep the glass clean when running the

stove very slowly for long periods.

If blackening of the glass still occurs check that all flue connections

and the blanking plate are well sealed. It is also important that the

chimney draw is sufficient and that it is not affected by down-

draught.. When the chimney is warm a draught reading of at least

2.5 mm (0.10 inches) water gauge (25Pa) should be obtained.

Some blackening of the glass may occur below the level of the fuel

retainer. This will not obscure the view of the fire or affect its

performance.

Fume Emission

Warning Note:

Properly installed, operated and maintained this appliance will

not emit fumes into the room. Occasional fumes from de-ashing

and re-fuelling may occur. Persistent fume emission is potentially

dangerous and must not be tolerated. If fume emission does

persist, then the following immediate actions should be taken:

a) Open doors and windows to ventilate the room and then leave

the premises..

b) Let the fire out and safely dispose of the fuel from the

appliance.

c) Check for flue or chimney blockage, and clean if required.

d) Do not attempt to re-light the fire until cause of fuming has

been identified, if necessary seek professional advice.

The most common cause of fume emission is flueway or chimney

blockage. For your own safety these must be kept clean.

CHIMNEY SWEEPING

TROUBLE SHOOTING

Where the chimney previously served an open fire, it is possible that

the higher flue gas temperature from a stove may loosen soot

deposits with the consequent risk of flue blockage. It is therefore

recommended that the chimney be swept a second time within a

month of regular use after installation.

The chimney should be swept at least twice a year. Where the top

outlet or vertical rear flue connector is used it will generally be

possible to sweep the chimney through the appliance.

First remove the fuel retainer and the throat plate. Then sweep the

chimney ensuring that soot is removed from all horizontal surfaces

after sweeping.

In situations where it is not possible to sweep through the appliance

the installer will have provided alternative means, such as a soot door.

After sweeping the chimney the appliance flue outlet and the flue pipe

connecting the stove to the chimney must be cleaned with a flue

brush.

After clearing any soot from within the stove, replace the throat plate

(see Fig. 3.) and the fuel retainer.

Fire Will Not Burn.

Check that:

a) the air inlet is not obstructed in any way,

b) chimneys and flueways are clear,

c) that a suitable fuel is being used,

d) that there is an adequate air supply into the room,

e) that an extractor fan is not fitted in the same room as the stove.

f) there is sufficient draw in the chimney. Once the chimney is warm a

draught reading of at least 2.5 mm (0.10 inches) water gauge (25Pa)

should be obtained.

Door Glass Blacks Up

Differences in chimney draughts mean that the best settings of the air

controls will vary for different installations. A certain amount of

experimentation may be required, however the following points

should be noted and with a little care should enable the glass to be

kept clean in most situations:

Different types of sweep’s brushes are available to suit different

flueways. For prefabricated insulated chimneys the manufacturers

instructions with regard to sweeping should be consulted.

OPERATING INSTRUCTIONS

charnwood

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood LA10 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info