Bedienungsanleitung Charnwood LA20i (Seite 11 von 16) (Englisch)

815487

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

FITTING THE OPTIONAL ADD-IN BOILER

FLUE CONNECTION AND INFILLING

The boiler replaces the rear firebrick and is reversible so that

the 1’’ B.S.P. male tappings may come on either the left or the

right hand side of the boiler.

The boiler tappings protrude from the sides of the appliance

and it will therefore be necessary to fit the boiler into the

appliance after positioning the appliance in the fireplace if the

fire surround is already fitted.

Before fitting the boiler, remove the front firebars, the side

and back fire plates and the firebricks. Knock out the knock-

outs for the boiler tappings on the appropriate side of the

firebox.

Remove the backnuts and fibre washers from the boiler

tappings and fit the boiler into the appliance. Place the fibre

washers over the tappings on the outside of the appliance and

fit the backnuts, ensuring that the boiler is held tightly against

the rear inside face of the appliance and that the top edge of

the boiler is level or runs uphill to the flow tapping.

When re-fitting the firebricks, note that the short side

firebrick supplied with the boiler must be fitted on the same

side as the boiler tappings. One of the original side firebricks is

fitted on the other side, and the rear firebrick is discarded.

The firebricks must be fire cemented into position, wetting the

firebox will improve the adhesion.

Replace the back fireplate, the side fireplates, the front firebar

and the throat plate.

Connect the boiler to the heating system ensuring that the

flow pipe rises from the boiler. Fill the system with water and

check for leaks.

Make the flue connection with the special 150°elbow part no.

010/AV12. Please note that this item is ordered separately

from the appliance. The legs of the elbow may be cut on site

to suit the chimney. Also note that the legs of the elbow are

different lengths to enable some situations to be catered for by

turning the elbow around.

The end of the flue pipe must line up with the centre-line of

the chimney, and must also extend to the point where the

chimney narrows to its final size. Any large voids must be

filled and flaunched to the flue pipe to ensure that all soot

deposits can be cleared when the appliance is swept, and to

prevent problems with the operation of the appliance.

Ensure that the flue pipe is not obstructed or restricted in any

way and that all joints are well sealed.

Before infilling cover the front of the appliance to protect it.

Ensure that the flue pipe is central and then fill the space

between the body of the appliance and the structural

brickwork with vermiculite (e.g. micafil or similar) concrete.

Ensure that there are no air pockets. The recommended mix

is six volumes of vermiculite granules to one volume of

Portland cement thoroughly mixed together. Enough water

should be added so that no more than one or two drops of

water are released when a handful of the mixture is

squeezed.

After filling with vermiculite concrete flaunch the top of the

flue connector pipe to the chimney with lime mortar. Ensure

that the flue pipe is well sealed to the chimney.

Make good the hole(s) in the chimney breast making sure that

it is completely airtight. A typical installation is shown in Fig. 7.

INSTALLATION INSTRUCTIONS

150°

Fig. 7. Typical Installation

Vermiculite

Infill

Flaunching

Take Flue Pipe

Up To Narrowest

Part Of Chimney.

Part No. 010/AV12

150° Elbow

charnwood

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood LA20i Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info