Bedienungsanleitung Charnwood SLX20 (Seite 8 von 20) (Englisch)

815482

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

d) there is an adequate air supply into the room,

e) an extractor fan is not fitted in the same room as the fire.

f) there is sufficient draw in the chimney. Once the chimney is warm

a draught reading of at least 2.5 mm (0.10 inches) water gauge

(25Pa) should be obtained.

Freezing

If a boiler is fitted do not light the fire if there is any possibility that

any parts of the system may be frozen.

Chimney fires

If the chimney is thoroughly and regularly swept, chimney fires

should not occur. However, if a chimney fire does occur then turn

the control knob to the minimum setting (see Fig. 1), and tightly

close the doors of the appliance. This should cause the chimney fire

to go out in which case the control should be kept at the minimum

setting until the fire in the appliance has gone out. The chimney and

flueways should then be cleaned. If the chimney fire does not go out

c) Check for flue or chimney blockage, and clean if required.

d) Do not attempt to relight fire until cause of fume has been

identified and corrected, if necessary seek professional advise.

The most common cause of fume emission is flueway or chimney

Blackening of Door Glass

blockage. For you own safety these must be kept clean.

Differences in chimney draughts mean that the best setting of the air

controls will vary for different installations. A certain amount of Fire Blazing Out Of Control

experimentation may be required. However, the following points Check that:

should be noted and with a little care should enable the glass to be

a) the doors are tightly closed,

kept clean in most situations:

b) the thermostat knob is turned down to the minimum setting and

a) The airwash relies on a supply of heated air to keep the glass

the airwash is closed,

clean, therefore, when lighting the stove allow the firebed to become

well established before turning the thermostat down. It may c) the air inlet damper is closed (at the bottom left of the appliance,

sometimes be beneficial to also keep the doors slightly ajar whilst the see Fig. 1.) and that it is not prevented from closing completely by a

fire becomes established. This can also apply when re-fuelling. piece of ash,

b) When re-fuelling keep the fuel back a little from the front firebars, d) a suitable fuel is being used,

do not try to fit too much fuel into the firebox. e) the door seals are in good condition.

c) Never completely close the airwash control - as a guide it should Over-Firing

be at least a quarter open.

If the fire is over-firing it will cause premature failure of the internal

d) Wet wood or logs overhanging the front firebars will cause the

fire parts. Over-firing is occurring when any internal parts of the fire

glass to blacken.

begin to glow red. To prevent over-firing ensure that:

It is always more difficult to keep the glass clean when running the

a) the door seals are kept in good condition, and that the doors are

stove very slowly for long periods.

sealing correctly,

If blackening of the glass still occurs check that all flue connections

b) the thermostat on the fire is working correctly,

are well sealed. It is also important that the chimney draw is sufficient

c) a suitable fuel is being used.

and that it is not affected by down-draught. When the chimney is

warm a draught reading of at least 2.5mm (0.10 inches) water gauge

should be obtained.

Fume Emission

Warning Note: Properly installed, operated and maintained this

appliance will not emit fumes into the room. Occasional fumes

from de-ashing and re-fueling may occur. Persistent fume emission

is potentially dangerous and must not be tolerated. If fume

emission does persist then take the following immediate actions

should be taken:

b) Let the fire out and safely dispose of the fuel from the

appliance.

a) Open doors and windows to ventilate the room and then leave

the premises.

charnwood

OPERATING INSTRUCTIONS SLX20

MU LTI-FUEL

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood SLX20 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info