Bedienungsanleitung Cisco 815 (Seite 18 von 28) (Englisch)

605005

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

8 Power Up the Router

This section provides the procedures for powering up your Cisco 815 integrated services router.

Caution To ensure adequate cooling, never operate the router unless the cover and all WICs and cover plates are installed.

Checklist for Power-Up

You are ready to power up the Cisco 815 integrated services router after the following steps are completed:

• Chassis is securely mounted and grounded. (See the “Install the Router” section on page 9.)

• Power and interface cables are connected. (See the “Connect to the Router” section on page 16.)

• PC with terminal emulation program is connected to the console port, powered up, and configured for 9600 bps, 8 data

bits, 1 stop bit, no flow control, and no parity.

• Suitable PC COM port is selected in the terminal emulation program.

Note For initial power-up, a direct console connection is recommended. After the initial configuration is completed, a remote

modem connection can be used for router management.

Powering Up the Router

Follow these steps to power up your Cisco 815 integrated services router and to verify that it goes through its initialization and

self-test. After the router completes the self-test, it is ready to be configured.

Note Use the back panel LEDs during router installation to confirm that you have correctly connected all the cables to the

router.

Note To view the boot sequence, you must have a console connection to the Cisco 815 integrated services router before it

powers up.

Step 1 Make sure that your PC is powered up and connected as described in the “Checklist for Power-Up” section.

Step 2 Move the power switch to the ON position. The SYS PWR LED on the front of the chassis blinks green. The fans

operate once the router reaches a threshold point temperature. If this does not happen, see the Troubleshooting module

in the online Cisco 815 integrated services router hardware installation documentation at the following URL:

http://www.cisco.com/en/US/products/hw/routers/ps380/prod_installation_guides_list.html

Startup messages appear in your terminal emulation program window. When the startup messages end, the SYS PWR

LED shows solid green.

Caution Do not press any keys on the keyboard until the messages stop and the SYS PWR LED is solid green. Any keys

pressed during this time are interpreted as the first command typed when the messages stop, which might cause the

router to power off and restart. It takes a few minutes for the messages to stop.

If you see the following messages, the router has booted with a configuration file and is ready for initial configuration

using Cisco Router and Security Device Manager (Cisco SDM):

yourname con0 is now available

Press RETURN to get started.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cisco 815 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cisco 815

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info