Bedienungsanleitung Clatronic bs 1260 (Seite 39 von 66) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Norwegisch)

319584

Zoom out

Zoom in

Vorherige Seite

1/66

Nächste Seite

ENGLISH

Instructions for Use

Intended Use

• The device is intended for use as a wet/dry vacuum cleaner

in accordance with its description and safety instructions.

• The device also has an additional connection with blower

function.

• Any other type of use is considered to be in contradiction of

the intended use and is not permitted.

Attaching the Castors

Before you can use the device you ﬁ rst have to attach the

castors.

• Place the collection vessel

(5) on its head.

• Attach the castors by tighte-

ning the screws by hand and

then with the spanner.

Inserting Dust Bags (only for Dry Vacuuming)

The device has a permanent dust bag. This is easy to empty

and can be cleaned.

• Lock the permanent dust bag

with the clip.

• Push the dust bag into the

holder (a).

Motor Protection Filter (15)

The motor protection ﬁ lter is located on the bottom of the motor

housing.

• This is required for both wet and dry vacuuming.

• You should check the condition of the ﬁ lter and that it is

ﬁ rmly in place at regular intervals.

Connecting the Hose

ޥ NOTE:

Do not attach the hose until you have inserted the dust bag

ﬁ rst.

• Attach the end of the hose

(connection) to the collection

vessel. The locking lugs on

the connecting piece grip

inside the vessel.

• Turn the connecting

piece slightly in a clockwise

direction. The catch lever (b)

points upwards.

• Releasing the hose: Push the catch lever and turn it in an

anticlockwise direction in order to release the hose from the

collection vessel.

Attaching the Motor Housing

ޥ NOTE:

• Between the motor housing and the collection vessel there

is a black rubber seal.

• Please ensure that this seal is always inserted and

correctly ﬁ tted in place. If this is not the case the suction

power is lost.

ޥ NOTE:

The motor housing can only be attached in one position. The

arrow above the hose connection must point to the arrow

below the on/off switch.

• Line the motor housing up in

such a way that its holder is

located above the clips (6) of

the collection vessel.

• Then close the clips.

Nozzle Attachment

Crevice nozzle: For vacuuming upholstery, curtains and

in corners and crevices etc.

Floor nozzle

(only for dry

cleaning):

To clean carpets or smooth surfaces.

Smooth

ﬂ oors

Press the lever down with your foot. The

brush is now visible.

Carpets

: Press the lever In the opposite direction.

The brushes are now retracted.

Parquet brush:

(also for wet

cleaning)

The ﬂ oor nozzle is ﬁ tted with rollers for

improved manoeuvrability. For large

areas such as parquet, laminate or tiles

etc. This brush is also ideally suited to

soaking up water from large surfaces.

Releasing the

nozzles

Pull these off while turning slightly.

Accessories

• The accessories such as the suction tube, hose and nozzles

can be easily joined together.

• Releasing: Pull them off again by turning slightly.

Air Slide

Open the air slide on the hose handle in order to regulate the

airﬂ ow or to clear any particles sticking to the nozzle.

05-BS 1260 39 19.09.2006, 12:54:56 Uhr

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic bs 1260 Seite 39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info