Bedienungsanleitung Clatronic BS 1312 A (Seite 48 von 86) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

814279

Zoom out

Zoom in

Vorherige Seite

1/86

Nächste Seite

BS1312A_IM 05.06.19

Nozzle Attachments (22, 23 and 24)

There are two different ways for connecting these nozzles

to the appliance:

Connection at the Hand Unit

• Note the recesses on the crevice nozzle and on the large

brush nozzle.

• Plug one of the nozzles into the port on the handset. It

must engage audibly.

• To release the respective nozzle, press the release but-

ton PUSH (16) while pulling it out at the same time.

Connection to the Suction Pipe

At the lower end of the suction pipe, you will nd the same

plug connection as on the handset. Mount / dismount the

nozzle as described above.

Crevice Nozzle

For vacuuming dirt from corners, joints and small gaps.

Large Brush Nozzle / Upholstery Brush

This nozzle is suitable for removing dust from sensitive

surfaces such as upholstery, furniture or curtains. The brush

head is rotatable.

Mini Special Brush

This special nozzle is particularly well suited for the gentle

cleaning of smaller surfaces such as keyboards.

Assembly the Wall Holder

Please take a look at the image of the wall bracket on

page 3.

WARNING:

Make sure beforehand whether there are cables in the

wall which could be damaged!

CAUTION:

Place the wall holder so that the appliance is not exposed

to direct sunlight or other heat sources.

NOTE:

If you would like to simultaneously use the wall mount as

a charging station, there must be a power outlet nearby.

1. Measure the height for the wall holder. Hold the vacuum

cleaner against the wall with the suction pipe and the

oor nozzle installed.

2. Plug the accessory holders onto the designated slots

(18, 19, 21) of the wall bracket.

3. On the back of the wall bracket, you will see two slotted

holes below one another. Draw two drill holes on the wall

at the distance of the slotted holes (about 154 mm).

4. Drill the marked holes and insert the dowels into the wall.

5. Fit the screws in such a way that the head sticks out a

few millimetres.

6. Install the wall bracket via the slotted holes using the two

screws. Ensure the screws are seated at the upper stop

of the slotted holes.

NOTE:

The wall bracket should be as close to the wall as pos-

sible. You may set the correct distance from the wall by

screwing the screws in or out.

7. You may attach the nozzles to the accessory holders on

the side.

8. Insert the power supply plug into the connector socket on

the upper side of the wall bracket (17).

Charging the Rechargeable Battery

CAUTION:

Do not charge the rechargeable battery unsupervised.

1. Turn off the appliance.

2. Connect the power adapter with the connection

socket (5). If you have prepared the wall holder as a

charging station, suspend the appliance from the wall

holder.

3. Connect the power adapter to a certied wall socket.

Charge the appliance for approx. 4 hours before rst-

time use.

NOTE:

• The indicator lights show the state of charge of the

rechargeable battery. (25 %, 50 %, 75 %, 100 %)

• The appliance has electronic charge control, which

prevents overcharging.

• Charging is completed when all 4 indicator lights

are lit. The electronics will switch to trickle charging.

Nevertheless, do not leave the appliance plugged-in

permanently to prevent possible damage to the

rechargeable battery.

• In case the appliance is removed from the charging

station or disconnected from the power adapter, the

indicator lights go out.

• It is normal for the appliance to heat up during

charging.

4. Disconnect the power adapter from the outlet once the

rechargeable battery has been charged completely.

NOTE:

Even when switched off, the rechargeable battery dis-

charges continuously. If the appliance is out of use for a

longer period of time, charge the rechargeable battery at

least once every 4 to 6 weeks.

Using the Appliance

You can use the appliance as a oor vacuum cleaner or as

a handheld and upright vacuum cleaner (basic appliance).

1. Disconnect the appliance from the power adapter.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic BS 1312 A Seite 48

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info