Bedienungsanleitung Clatronic BS 1312 A (Seite 49 von 86) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

814279

Zoom out

Zoom in

Vorherige Seite

1/86

Nächste Seite

BS1312A_IM 05.06.19

2. Turn on the appliance.

CAUTION:

• The suction opening must be free of blockages at all

times. Blockages will cause overheating and damage

to the motor.

• When the oor nozzle is blocked in such a way that

the brush roller can no longer rotate, the appliance will

switch itself off. The indicator lights start ashing alter-

nately. In this case, remove the blockage as described

in chapter “Cleaning” “Floor nozzle”. Then press the

On / Off button twice to resume operation.

NOTE:

• We recommend the higher power level for using the

appliance with the oor nozzle. The illumination of the

ECO button is off.

• During operation, depending on the charging capacity

of the rechargeable battery, 1 to 4 indicator are lit.

• We recommend recharging the battery once the indica-

tor lights show a remaining capacity of only 25 %.

• Once the capacity of the rechargeable battery is

almost reaching its end, all indicator lights will start

ashing for a few seconds. To avoid a deep discharge

of the rechargeable battery, the motor will shut off the

appliance accordingly. Recharge the battery.

End of Operation

1. Turn off the appliance.

2. If you have already installed the wall holder, hang up the

vacuum cleaner.

Maintenance

Emptying the Dust Container

1. Disconnect the appliance from the power supply unit.

2. If necessary, remove the suction tube or the nozzle

attachment from the appliance.

3. Hold the appliance with the bottom plate of the dust

container over a dustbin.

4. Empty the contents of the dust container. Press the

PUSH button (11) on the dust container to open the base

plate.

5. Then close the base plate again. The lock on the dust

container must engage.

The Filter System

Your appliance features 4 lters. The common dust bag

system has been replaced by a transparent dust container.

The higher ow speed of the container allows for heavy

dirt and smallest oating particles to be separated from the

“sucked-in air”.

It is thus not necessary to buy dust bags.

The lters must be cleaned periodically.

CAUTION:

• Never wash the lter in the washing machine.

• Do not use a hairdryer for drying.

• Only put the appliance back into operation when all

lters are completely dry and correctly assembled.

The Filter Unit

The lter unit is composed of:

• HEPA lter

• Coarse lter

Proceed as follows to clean the lter unit:

1. Empty the dust container as described above.

(Steps 1 - 5)

2. Disassembly of the Filter Unit

2.1 Slide down the MOVE lock (12) to separate the dust

container from the motor housing.

2.2 Remove the HEPA lter.

2.3 Remove the coarse lter from the dust container.

3. Cleaning the Filters

3.1 Hold both lters over a garbage can and tap out the

dust. You may also brush out the HEPA lter. In case

of heavy staining, clean the lters under running

water.

3.2 Let the lters air-dry completely before retting them!

3.3 Wipe the dust container with a damp cloth and then

wipe it dry.

4. Assembly of the Filter Unit

4.1 Place the coarse lter in the dust container. Please

note the recess on the edge of the dust container.

Now push the coarse lter down so that it is placed

in the centre of the dust container.

4.2 Place the HEPA lter back into the coarse lter. If

the rubber ring has come loose while cleaning, rst

reattach it on the open side of the HEPA lter (see

gure “Filter unit”). The lugs of the rubber ring must

fully t into the recesses of the coarse lter.

4.3 Then reattach the dust container to the handset.

First insert the hook into the recess on the motor

housing that is located on the bottom of the dust

container. Make sure the MOVE lock snaps audibly

into the handset afterwards.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic BS 1312 A Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info