Bedienungsanleitung Clatronic BS 1313 (Seite 10 von 58) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

814282

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

BS1313_IM_new - SH separat 13.02.23

11 Suction opening

12 Hose connection

13 Collection container

14 Attachment device for the nozzle attachments

15 Rollers

16 Chassis frame

17 Lever for extending and retracting the brush

18 Floor nozzle

Accessories

19 Crevice nozzle

20 Brush nozzle

Without Illustration

Permanent lter (for dry vacuuming)

Sealing ring (for wet vacuuming)

Protective foam lter

Warnings for the Use of the Appliance

WARNING:

• Only use the appliance in damp rooms if a residual

current circuit breaker has been connected upstream

in the circuit for your protection. If in doubt, consult an

authorised electrician.

• If the appliance, which is lled with water, should acci-

dentally tip over, always unplug it from the wall socket

before standing it up again.

• Never use it to suck up explosive liquids (such as

heating oil, petrol, paint thinner, acetone) and dusts

(such as magnesium and aluminium dusts), ammable

gases as well as undiluted solvents and acids, there

is a risk of explosion! Explosive vapours or mixtures

could be created by swirling the suction air. These

substances could attack the parts and materials used.

CAUTION:

• Pay attention to the limited range due to the cable

length!

• Switch off the appliance immediately in the following

situations:

- In case of foam formation.

- In case of liquid leakage.

- When the container is full.

- If the appliance is tipped over.

• Do not vacuum foam-forming cleaning agents with

the appliance!

• When vacuuming liquids, always remove the perma-

nent lter. Insert the sealing ring instead.

• Check that the protective lter is correctly seated.

• Before you vacuum dry again the next time, all compo-

nents must be dry again.

CAUTION:

• When vacuuming smooth oors dry with the oor

nozzle, be sure to use it with the brushes extended to

avoid damaging the oor.

Putting Into Operation

If not already done, remove the supplied parts from the

collection container.

Mounting the Carrying Handle

Mount the carrying handle with the two enclosed screws.

Hand-tighten the screws with a suitable screwdriver.

Mounting the Rollers

Before you use the appliance, fasten the rollers to the chas-

sis frame of the collection container.

1. Detach the motor housing from the collection container

by pressing the latches inwards.

2. Remove the motor housing from the collection container.

3. Place the collection container upside down.

4. Insert the rollers with the pins into the provided holes as

far as they will go.

5. Turn the collection container back round so that it stands

on the rollers.

Inserting the Filter

1. Insert the Permanent Filter

(only when Vacuuming Dry)

The appliance has a permanent

lter. It is easy to insert and clean.

• Put the rubber rim of the perma-

nent lter over the edge of the

collection container. It serves

as an airtight seal for the motor

housing.

2. Protective Foam Filter

A protective foam lter is located underneath the motor. It is

needed for both wet and dry vacuuming.

• If not already tted, place the protective lter on the

suction strainer.

• Regularly check that the lter is correctly tted and in

good condition.

Putting on the Motor Housing

• If you do not use the permanent lter, always attach the

supplied sealing ring. Fit it over the edge of the collection

unit.

- Ensure that this rubber seal always sits correctly on

the edge of the container. If this is not the case the

suction power is lost.

• Align the motor housing so that the on / off switch sits

above the intake opening.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic BS 1313 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info