Bedienungsanleitung Clatronic BS 1313 (Seite 11 von 58) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

814282

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

BS1313_IM_new - SH separat 13.02.23

• The latches on the appliance must be in the recesses

of the motor housing. Press the motor housing onto the

collection container until the latches engage.

Connect and Disconnect the Hose

Suction Function

Insert the hose connection into the suction opening on the

collection container. Pay attention to the recesses. Turn the

hose clockwise to tighten.

Fan Function

Insert the hose connection into the blow-out opening on the

motor housing. Pay attention to the recesses. Turn the hose

clockwise to tighten it.

Loosen the Hose

Loosen the hose by turning it anticlockwise and pulling it out.

3-part Suction Tube

• Insert the two suction pipes into each other without the

holder.

• Insert the thinner end of the assembled suction tubes

into the thicker end of the suction tube with holder.

• To detach the suction tubes, pull them off while turning

them slightly.

Nozzle Attachments

• To detach the nozzle attachments, pull them off with a

slight twist.

• There are several ways to store the brush nozzle and

crevice nozzle.

- Use the holders above the rollers or the holders on

the lid.

Floor Nozzle

You can clean smooth surfaces and carpets dry or wet with

the oor nozzle. The oor nozzle is equipped with rollers for

easier guidance.

• Use the lever to move the brushes outwards or inwards.

The optimal use depends on the condition of the oor. We

recommend the following use:

• Use without Brushes ( ):

- For vacuuming dry carpets (high pile).

- For cleaning wet, smooth oors.

This setting is also best suited for picking up water

from larger areas.

Note that the collection container can only hold a

limited amount of liquid! The maximum lling quantity

is reduced accordingly for foam-forming additives!

• Use with Brushes ( ):

- For vacuuming dry, smooth oors and dry carpets

(low pile).

- For cleaning (scrubbing) wet, smooth oors and wet

carpets (low pile).

Crevice Nozzle

For vacuuming in corners and slits, etc.

Brush Nozzle

For cleaning upholstery or curtains.

Air Slider

Open the air slider on the hose handle to regulate the air or

to loosen parts sticking to the nozzle.

Mains Cable

• For operation, unwind the mains cable completely.

• After operation, let the motor housing cool down rst. You

can then wrap the mains cable around the motor housing.

Switching On / Off

Use the on / off switch to turn the appliance on (I) and off (O).

Using the Appliance

Preparation

1. Select the desired accessory.

2. Unwind the mains cable completely.

3. Check that the mains voltage you want to use corre-

sponds to the information on the rating plate.

Vacuuming Dry

1. Place the permanent lter in the collection container.

2. Place the motor housing with the recesses on the latches

until they click into place.

3. Fit the accessories.

4. Insert the mains plug into a properly installed earthed

socket.

5. Switch on the appliance.

6. Now vacuum at a steady speed. It is not necessary to

press down.

Wet Vacuuming

1. Pull the mains plug out of the socket.

2. Remove the permanent lter. Insert the sealing ring

instead.

3. Fit the sealing ring over the edge of the collection unit.

4. Place the motor housing with the recesses on the latches

until they click into place.

5. Fit the accessories.

6. Insert the mains plug into a properly installed earthed

socket.

7. Switch on the appliance.

The collection container can only hold a limited amount

of liquid! If foam forms in the collection container, the

maximum collection volume is reduced accordingly!

When the container is full, the oat valve closes the

suction opening and the motor runs at increased speed.

Switch off and empty the appliance immediately.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic BS 1313 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info