814202
43
Zoom out
Zoom in
Vorherige Seite
1/78
Nächste Seite
EBG3760_IM 11.02.20
43
Overview of the Components /
Scope of Delivery
1 Air outlet openings
2 Housing
3 On / off switch ( / O)
4 Control dial / START / STOP button (start / stop)
5 TEMP button (temperature)
6 TIME button (time)
7 Display
8 Grease drip tray
9 Grill rack
No illustration:
Removal tool
Notes for Use
Location
Set the appliance onto a non-slip, level, and heat-resist-
ant surface.
Take care that the appliance and the mains cable never
are placed onto hot surfaces or near heat sources (e. g.
range, hob).
Connected Wattage
The total power consumption of this appliance can be up
to 1600 W. With this connected load a separate supply line
protected by a 16 A household circuit breaker is recom-
mended.
CAUTION: Overload!
If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
Do not use any multiple sockets, as this appliance is
too powerful.
Electric Connection
1. Before inserting the power plug into the outlet, check
that the mains voltage to be used matches that of the
appliance. You can nd the required information on the
nameplate.
2. Connect the appliance to a properly installed earthed
socket.
Switching the Appliance On / Off
The on / off switch is located at the back of the appliance:
O = turned off
I = turned on
When turning on the appliance, a signal will sound and the
fan will turn on for about 3 seconds. The display will then
show “ ” next to the TEMP button and “ ” next to
the TIME button. In addition, all the indicator lights light up
briey.
Standby (Standby Mode)
NOTE:
The appliance is in standby mode when the power plug
is plugged in, the switch is set to the position and the
display is not on.
If no button is pressed for approx. 3 minutes, the appli-
ance will automatically switch into standby mode.
You may exit standby mode by either pressing a button
or by using the control dial.
Buttons and Controls on the Control Panel
The TEMP and TIME buttons on the appliance are touch
keys. Gently touch the buttons with a nger to execute
the function. Whenever a button is pressed, it will be
conrmed by a beep sound.
The control dial has two different functions:
Turning:
- Selection of the automatic programs
- Change of temperature or time
Pressing:
- Starting and stopping the programs
Auto Functions
Use the control dial to select an automatic program. The
corresponding indicator light indicates the selected program.
Mode Pre-set
temperature in °C
Pre-set time
in min.
(Entrecôte) 850 3
(Roast beef) 850 5
(T-Bone) 850 7
(Fillet) 800 4
(Chicken) 850 4
REST (Simmering) 300 5
NOTE:
These shall be considered as guide values. Depending
on the size and weight, the time and temperature may
be longer and higher or shorter and lower.
You may change the pre-set temperature and time of
the automatic programs as desired. However, this is
not possible with the REST ” program.
Turn the meat over halfway through the cooking time.
Changing the Temperature
Press the TEMP button. The temperature display will start
ashing for about 3 seconds. During this time, use the
control dial to set the temperature.
43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Clatronic EBG 3760 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info