Bedienungsanleitung Climastar Silicium Touch (Seite 8 von 12) (Englisch)

773865

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

3.7 KEY BLOCK FUCTION

This function enables to block the controls. To set this function, do as follows:

a) Press the 'OK/mode' button for a few seconds until (Configure Time) is displayed.

b) Repeatedly press the button until is displayed and then press the 'OK/mode' button.

c) Press the button until is displayed and then press the 'OK/mode' button.

The display now shows to indicate the controls are now locked.

To unlock the device, wait until the dashes disappear and the display shows the temperature then press

and hold down the ' /esc' button for 5 seconds until the dashes are shown again, now press the button

to confirm.

3.8 SOUND FUNCTION

The SOUND function enables you to activate and deactivate the beep emitted on touching the buttons. To

activate or deactivate the sound do as follows:

a) Press the 'OK/mode' button for a few seconds

b) Repeatedly press the button until is displayed and then press the 'OK/mode' button.

c) Press the button to select (to activate) or (to deactivate) the beep and press the 'OK/mode'

button to confirm.

3.9 OTHER INFORMATION

 If you enter a submenu, and stop using the device for a few seconds, it will automatically return to the main

menu.

 If you are in the main menu, and the device is not being manipulated; it will turn to stand-by mode and the

display will only show a dot. To turn on the screen again, press any key on the button panel.

 Even if the device is in an OFF cycle, the radiator can still start working. This is because it has a minimum

frost protection set temperature as per factory set to 7ºC. This mode is called FROST PROTECTION and it

prevents the room temperature going below 7ºC temperature.

 The device also has a built in sensor that detects any sudden temperature changes that may occur, i.e. when

a window is opened, air conditioners activated, or any other circumstance that may prevent the radiator from

raising the room temperature. This mode activates when the temperature decreases by 3ºC in 5 minutes. At

this stage, the radiator turns off and shows on the display; this mode stays until this decreasing

tendency disappears.

5. Cleaning and Maintenance

 The radiators do not require any special maintenance providing thermal comfort during large periods. Dust

clean with a dry, soft cloth only when the unit is disconnected and cold.

 At the beginning of the year’s heating season, vacuum any dust that has accumulated in the inner heating

element while the radiator has been off for long periods during warmer weather.

 Do not use solvents or abrasive products for cleaning.

 After the heating season turn off the radiator with the switch located on the right side of the radiator.

 This inertia radiator has been manufactured under an assured quality system using environment friendly

processes.

 Disposal: Please take the radiator to a recognised disposal point so any useful material is recycled in the

right way.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Climastar Silicium Touch Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info