Bedienungsanleitung Constructa CD669862 (Seite 12 von 32) (Deutsch, Englisch, Holländisch, Französisch)

596538

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Operating the appliance

These instructions apply to several appliance variants. It is

possible that individual features are described which do not

apply to your appliance.

Note: Switch on the extractor hood when you start cooking and

switch it off again several minutes after you have finished

cooking. This is the most effective way of removing the kitchen

fumes.

Control panel

Setting the fan

Note: Always adjust the fan strength to meet current conditions.

If there is a large build-up of steam or fumes, select a high fan

setting.

Switching on

Press button 1, 2 or 3.

To confirm the setting, the 0 button and the set fan speed light

up.

Switching off the appliance

Press the 0 button.

Fan run-on time

The fan run-on is possible in any fan speed.

1. First, press the button for the required fan speed 1, 2 or 3.

2. To activate the fan run-on, press and hold the % button for

2 seconds.

To confirm the setting, the 0 button and the set fan speed

flash.

3. To end the fan run-on early, press the 0 button.

Notes

■ The run-on time for all fan speeds is 30 minutes. Once this

time has elapsed, the ventilation and lighting automatically

switch off.

■ The fan speed can be changed during the run-on time.

Intensive setting

You can use the intensive setting if there is a large build-up of

odours and fumes/vapours.

1. To activate the intensive setting, press and hold the g button

for 2 seconds.

To confirm the setting, the 0 button lights up and the g button

flashes.

2. To end the intensive setting early, press the 0 button.

Note: The time of the intensive setting is 6 minutes. Once this

time has elapsed, the appliance switches back to the fan

setting that was previously set.

Lighting

The lighting can be switched on and off independently of the

ventilation.

Press the @ button.

Setting the brightness

When switching on the lights, press and hold the @ button for

2 seconds. The brightness is reduced.

Note: When switching on the lights again, the brightness is set

to maximum once again.

Cleaning and maintenance

: Risk of burns!

The appliance becomes hot during operation. Allow the

appliance to cool down before cleaning.

: Risk of electric shock!

Penetrating moisture may result in an electric shock. Clean the

appliance using a damp cloth only. Before cleaning, pull out the

mains plug or switch off the circuit breaker in the fuse box.

: Risk of electric shock!

Do not use any high-pressure cleaners or steam cleaners,

which can result in an electric shock.

: Risk of injury!

Components inside the appliance may have sharp edges. Wear

protective gloves.

Cleaning agents

Observe the information in the table to ensure that the different

surfaces are not damaged by using the wrong type of cleaning

agent. Do not use

■ harsh or abrasive cleaning agents,

■ cleaning agents with a high concentration of alcohol,

■ hard scouring pads or sponges,

■ high-pressure cleaners or steam cleaners.

Wash new sponge cloths thoroughly before use.

Follow all instructions and warnings included with the cleaning

agents.

Explanation

0 Fan off

1 Fan speed 1

2 Fan speed 2

% Fan run-on

3 Fan speed 3

g Intensive setting

A Light on/off

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Constructa CD669862 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info