Bedienungsanleitung Constructa CF234653 (Seite 40 von 48) (Englisch, Holländisch)

542391

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Self-cleaning surface

The back wall of the cooking compartment is coated with self-

cleaning enamel. This coating absorbs and disintegrates

splashes from baking and roasting while the oven is in

operation.

Large splashes only disappear after the oven has been used

several times.

Discolouration on the rear wall does not affect the self-cleaning

function.

Caution!

Damage to surfaces on self-cleaning areas due to applying

oven cleaner.Never clean the self-cleaning surfaces with oven

cleaner.

If oven cleaner accidentally gets onto self-cleaning surfaces,

remove it immediately with a sponge and plenty of water.

Caution!

Damage to surfaces on self-cleaning areas due to the use of

abrasive and acidic cleaning agents and aids.

Do not use cleaning agents containing abrasive substances or

acids.

Do not use abrasive cleaning aids such as steel wool or

scourers.

Hydro Clean®

To make it easier to clean the cooking compartment, your

appliance is equipped with the > Hydro Clean® cleaning aid.

An automatically controlled vaporisation of soapy water loosens

residues and makes it easier to remove them afterwards.

For heavy dirt deposits, you can

■ leave the soapy water to work for some time before switching

on the cleaning aid

■ rub the dirty areas with detergent before switching on

■ repeat the cleaning aid process after leaving the cooking

compartment to cool

Preparation and switching on

Hydro Clean® only starts when the cooking compartment has

cooled down.

If, after Hydro Clean® is switched on, • or œ and ’– appear

alternately in the temperature display, the cooking compartment

is not completely cooled. Wait until the cooking compartment

has cooled down, and switch Hydro Clean® on again.

: Risk of scalding and surface damage!

Never pour water into the cooking compartment when it is hot.

Water vapour will be created and the enamel may be damaged

because of the change in temperature.

1.Remove the accessories from the cooking compartment.

2.Carefully pour 0.4 litres of water (not distilled water) with

some detergent into the base trough of the cooking

compartment (fig. A).

3.Close the appliance door.

4.Switch on the > Hydro Clean® operating mode.

’– appears in the temperature display. Once the cleaning aid

is complete, the oven lighting switches on. A signal sounds.

5.Press the clock function button to exit the clock function.

Switching off and rinsing

Do not leave the remaining water in the cooking compartment

for a long time (e.g. overnight).

1.Open the appliance door and remove the remaining water

with an absorbent sponge cloth (figure B).

2.Clean the cooking compartment with a sponge cloth, a soft

brush or a plastic saucepan scrubber. Remove any

remaining, persistent residue with a glass scraper for glass

ceramic.

3.Remove limescale with a cloth soaked in vinegar, then wipe

with clean water and rub dry with a soft cloth. Remember to

dry under the door seal.

4.Turn the operating mode selector back to the Û position.

5.After cleaning, leave the appliance door ajar in the stop

position (approx. 30°) for approx. 1 hour to allow the enamel

surfaces in the cooking compartment to dry thoroughly.

Rapid drying

1.After cleaning, leave the appliance door ajar in the stop

position (approx. 30°).

2.Set the 3 Hot air to 50°C.

3.After 5 minutes, switch off the appliance and close the

appliance door.

Removing and fitting the appliance door

You can remove the appliance door to clean it more

thoroughly.

: Risk of injury!

The hinges of the appliance door may snap shut with great

force. Always open the hinge locking lever fully when removing

the appliance door and close it fully after refitting. Do not reach

into the hinge.

: Risk of injury!

If the appliance door has only been unhinged on one side, do

not reach into the hinge. The hinge can snap back with great

force. Call the aftersales service.

Removing the appliance door

1.Open the appliance door fully.

2.Open the locking levers on the left and right-hand side fully.

The hinges are secured and cannot snap closed.

3.Close the appliance door until resistance becomes

noticeable (figure A).

4.With both hands, grip the door on the left and right-hand side,

close the door a little more and pull it out (figure B).

$ %

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Constructa CF234653 Seite 40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Constructa CF234653

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info