Bedienungsanleitung Crivit RG 4791 IAN304119 (Seite 27 von 86) (Deutsch, Englisch, Holländisch, Französisch, Polnisch)

736216

Zoom out

Zoom in

Vorherige Seite

1/86

Nächste Seite

CAUTION: Check the plus/minus poles

of the batteries (30) and that they are in-

serted correctly, as marked on the bottom

of the battery compartment (10d).

3. Attach the battery compartment cover (10c) on

the back of the cockpit and tighten the screws

back in again.

Replacing the batteries

CAUTION: Observe the following

instructions to avoid mechanical

and electrical damage.

Should the batteries (30) no longer function,

replace them as described in the insertion instruc-

tions above. Remove the batteries that are in the

device before inserting new ones.

Notes on setting up

• Choose an exercise area of approx.

3.00 x 1.80m (L x W).

• Train on a ﬂat and non-slip surface only.

Assembly

The item should be assembled by two

people.

Step 1 (Fig. C):

1. Attach the two front legs (7a), (7b) to the front

foot (3).

Note: Make sure that the curved part on the two

legs (7a), (7b) are each face outwards.

2. Then attach the two long legs (7a), (7b) to the

base frame (1).

Note: To make it easier to assemble the legs, turn

the base frame so that the bolt holes are facing

upwards.

Step 2 (Fig. D):

1. Leave the base frame (1) in the inverted state

and mount the centre leg (9).

Note: After completing the assembly of the

rowing machine, the floor height level can be

adjusted with the thumbscrew.

2. Adjust the ground levelling with the thumbscrew

and then tighten the lock nut (9a).

Step 3 (Fig. E):

1. Leave the base frame (1) in the inverted state

and mount the two footrests (6a), (6b).

Note: Make sure they are correctly oriented (left

(6a)/right (6b)).

Step 4 (Fig. F):

1. Attach the two rear legs (8a), (8b) to the rear

foot (4).

Note: Make sure that the curved part on the two

legs (8a), (8b) are each face outwards.

2. Slide the metal plate (15) into the slide rail (2)

and attach the rear legs (8a), (8b) to the slide

rail (2).

Note: Make sure that the threaded holes on the

metal plate (15) are directly under the holes on

the slide rail (2).

Step 5 (Fig. G):

1. Slide the saddle (5) from behind onto the slide

rail (2). To do this, direct the gliding carriage

under the seat into the guide on the slide rail.

Note: Make sure the seat is correctly oriented.

2. Attach the stoppers (13) to the right and left on

the front and back end of the slide rail (2).

3. Insert the cover panel (14) onto the back end

of the slide rail (2).

Step 6 (Fig. H):

1. Place the base frame (1) and the slide rail (2)

on the respective feet.

2. Insert the slide rail (2) in the base frame (1)

and screw it tight. Make sure the two sensor

cables are not crushed or damaged when

inserting the slide rail (2).

3. Fold the slide rail up (2) and insert the connec-

tor of the sensor cable (1a) into the corre-

sponding bushing (2a) of the slide rail.

Step 7 (Fig. I):

When in the unfolded state, the slide rail (2) must

be stabilised with the safety bolt (11).

1. Put the bushing (12) on the safety bolt (11).

2. Screw the safety bolt (11) from below into the

threaded hole provided on the slide rail (2).

Note: Tighten the locking screw (11) so that

the rowing machine has a stable footing during

training.

Step 8 (Fig. K):

1. Connect the two sensor cables of the cockpit

(10a) with the sensor cables of the base frame

(1b).

2. Screw the cockpit holder (10b) firmly to the

base frame (1).

GB/IE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Crivit RG 4791 IAN304119 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info