Bedienungsanleitung Croozer Kid Keeke 2019 (Seite 18 von 48) (Englisch)

772388

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

16 CroozerKid-Kid20-ENG-10-19

Converting the Croozer to a Bicycle Trailer

axle nut adequately may result in accidents with serious

injury or death. If it is not possible to tighten the axle nut

five full turns, then the quick-release skewer is too short

and must be replaced. Consult a professional bicycle

mechanic for the appropriate parts and assistance.

5. Check that the rear wheel of the towing bicycle is

properly aligned, adjusting the position if necessary;

then close the quick-release lever or tighten the Allen

bolt, depending on the type of quick-release skewer.

Often, the closed position is indicated on the lever

by the word “CLOSE”. In this case, when the lever

side marked “CLOSE” can be seen, the lever is in the

closed position. If the axle nut has been tightened the

proper amount, you will be able to feel the resistance

increase when the lever is about halfway closed, i.e.

parallel to the axle. The adjustment is correct if you

can fully close the lever but with considerable force. In

the closed position, the lever should be parallel to the

frame, i.e. it should not stick out to the side.

6. Check whether the quick-release skewer is securely

engaged by trying to rotate the quick-release skewer

without opening the lever.

If the quick-release is loose enough to rotate, then the

clamping force is inadequate. In this case, open the

lever, and tighten the axle nut half a turn clockwise.

Repeat steps 5 and 6.

If it is impossible to push the quick-release lever into

the closed position, then open the lever, and unscrew

the axle nut half a turn anticlockwise. Repeat steps 5

and 6. Keep in mind that the axle nut must engage the

threads of the quick-release skewer for at least ve full

turns.

The axle nut must engage the threads for at least five

full turns in order to ensure adequate clamping force for

holding the rear wheel securely. Failure to tighten the

axle nut adequately may result in accidents with serious

injury or death. If it is not possible to tighten the axle nut

five full turns, then the quick-release skewer is too short

and must be replaced. An extra-long quick-release axle is

available as an accessory. Consult a professional bicycle

mechanic for the appropriate parts and assistance.

Tip: If there is not enough space for mounting the axle

hitch or if the skewer threads are too short, then you

can replace the original skewer with a Croozer Click

& Crooz® Quick Release Skewer with integrated

hitch, which is available as an accessory.

7. Finally, hold the rear wheel with both hands and try to

rock it back and forth to check that the wheel is held

securely in the dropouts.

The rear wheel of the towing bicycle must be properly

installed after the axle hitch has been mounted. Riding

with an improperly installed rear wheel can result in acci-

dents with serious injury or death. Follow the instructions

and warnings given in the owner’s manual of the towing

bicycle. There are many different types of axles. When in

doubt, consult a professional bicycle mechanic.

Accessory

www.croozer.com

www

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Croozer Kid Keeke 2019 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info