Bedienungsanleitung Croozer Ski-Set (Seite 23 von 44) (Deutsch, Englisch, Französisch)

772438

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

CroozerSkiSet16-D-9-15

Installing and removing the Croozer Ski Set

Kid

Step B: Attaching the skis to the ski adapters

1. Make sure that the ski bindings are adjusted to a boot-

sole length of 235 mm (9.25 inch).

2. The tension of the ski bindings must be adjusted to the

maximum release/retention setting because, if the set-

ting is to low, the skis could come loose or fall off while

the trailer is in use. Have the release setting of the ski

bindings adjusted by a professional ski shop. Be sure

to follow the instructions given in the manual for your

ski bindings.

After removing the ski adapters, be sure to have your

ski bindings readjusted to the skier by a professional ski

shop. Using skis with incorrectly adjusted ski bindings

could cause accidents with serious injury or death.

3. The ski adapters are marked with the letters “L” and

“R”. Attach the left ski adapter to the left ski by  rst

slipping the front plate (1) of the adapter into the front

of the binding and then pressing down on the heel

plate (2) to lock the adapter into the binding. Use the

same procedure to attach the right adapter to the right

ski.

Tip: Pulling up on the heel lever of the binding will make

it easier to lock in the adapter.

Step C: Attaching the ski adapters to the

Croozer Kid or Kid Plus

The ski adapters are equipped with push-button axles.

When you press the button (3), the retaining balls (4) that

lock the axles into the receivers will retract within the axle.

The adapters with skis cannot be attached or removed un-

less the button is pressed. The heel plates of the ski adapt-

ers are marked with the letters “L” and “R”. Be sure to

mount each ski adapter to the correct side of the Croozer.

1. Use one hand to lift up the back of the Croozer Kid or

Kid Plus.

2. Press the button (3) of the adapter axle.

3. Croozer Kid Plus: Insert the adapter axle (5) all the

way into the axle receiver (6) in the suspension swing

arm of the Croozer Kid Plus, and release the button.

Croozer Kid: Insert the adapter axle (5) all the way into

the axle receiver in the frame of the Croozer Kid, and

release the button. (Not pictured)

4. Now check that the ski adapter is securely locked into

the receiver by pulling on the adapter without pressing

the button. It should not be possible to remove the ski

adapter.

5. Repeat these steps to attach the second ski adapter.

After the ski adapters have been attached, be sure to

check that they are both locked securely into the axle

receivers. This can be done by pulling on the ski adapt-

ers without pressing the buttons. It should not be possible

to remove the ski adapters unless you are pressing the

buttons. Ski adapters that are not securely locked into

the axle receivers could fall off while skiing, resulting in

accidents with serious injury or death.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Croozer Ski-Set Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info