Bedienungsanleitung Cullmann D 4500 (Seite 12 von 38) (Holländisch)

447858

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

22 23

Reﬂection Plate and Diffuser

The ﬂash unit has an integrated reﬂection plate

and a diffuser. You can slide out the reﬂection

plate or the diffuser on the upper side, swivel the

ﬂash head and use the reﬂection plate to shoot

photos with a heavy effect. The diffuser can

reduce the strong light, creating soft effects.

Using the diffuser is recommended to achieve

ideal results at close proximity (1 – 3 yards).

Energy-Saving Function

To save electricity, the ﬂash unit automatically

switches off approximately 3 minutes after it has

been switched on or since the most recent ﬂash

was released. The LCD display indicates the

“OFF” signal. To reactivate the ﬂash unit, simply

press any button switch below the LCD display

table or switch the main switch off and back on.

The ﬂash unit is not full switched off in the

energy-saving function setting, but its energy use

is drastically reduced. When you are no longer

using the ﬂash unit, set the main switch to “OFF”.

ENG

Power-Zoom

Automatic control of the motorized zoom

When using zoom lenses that transmit their focal

widths to the camera, the camera forwards this

information to the ﬂash unit. Then the ﬂash unit

automatically adjusts its zoom position. The

automatic reﬂector control of the motorized zoom

is possible with cameras that permit the digital

transmission to the ﬂash unit.

The LCD display on the ﬂash unit indicates zoom

positions of 24-28-35-50-70-85 mm. When the

ﬂash unit is switched on, the zoom is activated

and the position is set at 35 mm. As soon as the

camera’s release is touched only slightly, the focal

width of the ﬂash unit is automatically adapted to

the focal width of the lens.

Whenever the ﬂash head is not at the normal set-

ting (pointing forwards) whereby it is in another

position, the zoom position clicks to 50 mm and

is indicated in the LCD display by a short ﬂash in

the Auto mode.

Manual Control of the Motorized Zoom

With the “Zoom” button, you can alter the

reﬂector position of the zoom independently

of the focal width of the lens. The LCD display

then indicates “M” and the current setting of the

reﬂector’s zoom position.

Light tapping of the “Zoom” button changes the

zoom position in this order: 24-28-35-50-70-85 mm.

Receiver Function

This ﬂash unit can be operated as a wireless re-

ceiver by setting the switch “Slave Mode” to the

S position. The ﬂash unit switches automatically

to the M mode with an energy ration of 1:1 and a

focal width of 24 mm. When the sensor discovers

the release of an extreme ﬂash, the ﬂash is

released simultaneously. The quantity of the light

emission can be selected by setting the energy

ration from 1/1 to 1/8. If several ﬂash units

are used as receivers, then the corresponding

quantity of light must be taken into consideration

in order to calculate the correct lighting. If the

reception mode is activated, the energy-saving

mode does not operate.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cullmann D 4500 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info