Bedienungsanleitung Cupra Formentor e-HYBRID - 2023 (Seite 24 von 396) (Englisch)

810364

Zoom out

Zoom in

Vorherige Seite

1/396

Nächste Seite

Driver information

–

Range can be increased by reducing or switch-

ing o comfort consumers, e.g. air condition-

ing or seat heating.

Speed warning for winter tyres

If the maximum set speed is exceeded, this is

displayed on the instrument cluster display.

The speed warning can be set in the infotain-

ment system ›››page35.

Low consumption driving

Depending on the equipment, when driving,

the display appears on the instrument panel

when the vehicle is in low consumption status

due to active cylinder management (ACT®)

›››page146.

WARNING

Even when the outside temperature is higher

than freezing temperature, some roads and

bridges could be frozen.

●The “ice crystal symbol” indicates that

there may be a risk of freezing.

●At outside temperatures above +4°C

(+39°F), there may be ice even when the “ice

crystal symbol” is not on.

●The outside temperature sensor takes a

guideline measurement.

Note

●There are dierent instrument panels and

therefore the versions and instructions on

the display may vary. In the case of displays

without warning or information texts, faults

are indicated exclusively by the control warn-

ing lamps.

●Some indications on the instrument panel

screen may be concealed by a sudden event,

e.g. an incoming call.

●Depending on the equipment, some set-

tings and instructions can be carried out or

displayed on the infotainment system as well.

●If there are several warnings at the same

time, the symbols will be displayed one after

the other for a few seconds. The symbols will

stay on until you remove the cause.

● If when switching on the ignition warnings

are shown about existing faults, it might not

be possible to change the settings or show

the information as described. In this case,

go to a specialised workshop and request a

repair.

Driving data indicator

The driving data display shows a range of driv-

ing data and consumption values.

Change from one display to another

● Turn the right thumbwheel of the multifunc-

tion steering wheel ›››page30.

Changing memory

● Depending on the view, select Driving

data and press the left arrow or the button

on the multifunction steering wheel.

Since start: The memory is deleted if

the journey is interrupted for more than 2

hours.

Since refuel: Display and storage of

the journey data and the consumption val-

ues collected. When refuelling, the mem-

ory is deleted.

Long-term: This memory contains travel

data up to a maximum of 19hours and

59minutes or 99hours and 59minutes, or

up to a maximum of 1999.9 km or 9999.9

km. When one of these values is exceeded

(varies depending on the version of the

instrument panel), the memory is deleted.

Delete journey data presets

● Select the memory that you wish to erase.

●Keep the button on the multi-function

steering wheel pressed for approximately 2

seconds.

Select the instructions

On the instrument cluster, it is selected man-

ually using the button on the multifunction

steering wheel. To access the contents of the

tube, rotate the right hand thumbwheel up/

down.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Formentor e-HYBRID - 2023 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Formentor e-HYBRID - 2023

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info