Bedienungsanleitung Cupra Formentor e-HYBRID - 2023 (Seite 338 von 396) (Englisch)

810364

338

Zoom out

Zoom in

Vorherige Seite

1/396

Nächste Seite

336

Checking and relling levels

NOTICE

●Never connect or disconnect the 12-volt

battery when the ignition is switched on or

the engine is running. Also, never use a 12-

volt battery that does not meet the vehicle's

battery specications. The electrical system

or certain electronic components could be

damaged and electrical malfunctions could

occur.

●Never connect accessories that supply

power, such as solar panels or battery charg-

ers, to the 12-volt socket or cigarette lighter,

to charge the 12-volt battery. This could

damage the vehicle's electrical system.

For the sake of the environment

● The battery may contain toxic substances,

such as sulphuric acid and lead. Dispose of

the 12volt battery in accordance with the

applicable regulations.

●Electrolyte can contaminate the environ-

ment. If any operating uid leaks out, collect

it and dispose of it properly.

Troubleshooting

Alternator fault

Only valid for: conventional vehicles.

The control lamp lights up in RED.

The vehicle battery stops charging from the

alternator. You should immediately drive to the

nearest specialised workshop.

You should avoid using electrical equipment

that is not absolutely necessary because this

will drain the battery.

12 volt battery

The control lamp lights up in RED. The follow-

ing messages may be displayed:

Error: 12 V battery not charging.

Stop vehicle safely!

Error: 12V power supply. Stop

safely! Manual!

Stop driving! Stop the vehicle at the next

opportunity and in a safe place. The 12-volt

battery will not be charged while driving or

there is a fault in the on-board 12-volt network.

●Switch o the ignition and any electrical con-

sumers that are not required.

●Contact a specialised workshop.

●Request a check of the electrical system.

12 volt battery

The indicator lamp lights up YELLOW. The fol-

lowing message is displayed:

Error: 12 V vehicle battery. Engine

cannot be started. Go to the work-

shop.

There is a fault in the connection between the

on-board network and the 12-volt battery.

If the drive system is switched o in this situa-

tion, it cannot be switched on again. If neces-

sary, use the jump leads ›››page310 or seek

assistance from qualied personnel.

●Contact a specialised workshop.

●Request a check of the electrical system.

12 volt battery

The indicator lamp lights up YELLOW. The fol-

lowing message is displayed:

Low level of the 12 V vehicle bat-

tery. Charge while driving

Starting capacity may be limited. If this driver

message goes out after a certain amount of

time, the vehicle's battery has recharged while

driving and reached a suicient level. If the

driver message does not go out, take the vehi-

cle to a specialized workshop.

12 volt battery

The indicator lamp lights up YELLOW. The fol-

lowing message is displayed:

Replace the 12V vehicle battery.

Please visit workshop.

The 12volt battery has almost reached the end

of its service life.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Formentor e-HYBRID - 2023 Seite 338

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Formentor e-HYBRID - 2023

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info