481718
24
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
23
De Dietrich Gas 310/610 ECO
7.3.6 Continued
CLV system application (Different Pressure Zones)
This venting system uses two separate vents that terminate a
different points of the building (2 different pressure zones), a
vent for combustion air and another for the flue gases. All
combustion air is from the outdoor source. The vent terminal
shall discharge flue gases away from the building structure so
that the flue gases do not cause damage to the building. The
vent terminal locations follow local and national codes
requirements. [See section 7.3.9]
7.3.7 Sidewall vented application with or without direct vent (sealed combustion air):
Caution Warning:
Flue gas condensation is very aggressive and corrosive
which could lead to failure of the venting system or
drains, consult local and national codes regarding flue
gas condensation disposal. The P-trap assembly must
be properly filled with water to avoid escape of the flue
gas emissions. The flue gas condensation may require
neutralization prior to entering the drain.
Warning:
An improperly sealed venting system could result in
carbon monoxide poisoning; ensure adequate support
and fastening of the system. Ensure venting can safely
exhaust all flue gases to the outside in a safe and
effective manner. Do not puncture or drill holes in any
portion of the venting, the boiler is equipped with a
pressure and emission test port. All venting must be
arranged to avoid and prevent the accumulation of flue
gas condensation.
CLV vent systems venting length chart
Gas 310/610
Model
Vent ø
Vent Length
[Min]
Vent
Length
[Max]
90° Elbow =
Length
45° Elbow =
Length
inch
mm
Ft.
m
Ft.
m
Ft.
m
Ft.
mm
310-5
10 250 5 1.5 180 54 12 3.5 6.5 2
310/610-6
310/610-7
310/610-8
310/610-9
Table 04[c] - venting length chart.
Table also applies to Gas 610 models.
L = Max
Gas310 Eco Boiler
[Left hand version shown]
CLV (different pressure zones) application with
Direct vent (Sealed Combustion Air) supply
L = Max
Fig. 8
Gas310 Eco Boiler
[Left hand version shown]
Sidewall vented application with or without
Direct vent (Sealed Combustion Air) supply
L = Max
Fig. 9
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für De Dietrich Gas 610 ECO wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info