Bedienungsanleitung Defort DGI-800 (Seite 7 von 88) (Alle Sprachen)

555813

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

Electricity

• Do not touch the generator if you have wet hands.

• Do not operate the generator in wet conditions.

• Do not operate the generator near water.

• Never connect two generators together.

• Never connect the generator to any commercial power

outlet.

• Make sure any extension cords used are in a safe con-

dition and of suf cient capacity for the task.

• Ensure that the load on the generator falls within its

capacity as speci ed in the table before plugging in any

cords.

To prevent an electric shock, make sure to ground

the generator. Connect a piece of cable between the

ground terminal on the generator and an external

ground point.

Fire and burn hazards

• The exhaust system gets hot enough to ignite some

materials:

- keep the generator at least 1 meter away from build-

ings and other equipment during operation.

- keep  ammable materials away from the generator.

• The exhaust becomes very hot during operations and

remains hot for a while after stopping the engine:

- Let the engine cool before storing the generator in-

doors.

- Do not touch the hot exhaust with your hands.

• Gasoline is extremely  ammable and is explosive un-

der certain conditions. Do not smoke or allow  ames or

sparks where the generator is refueled or where gaso-

line is stored.

• Fuel vapors are extremely  ammable and may ignite

after the engine has started. Make sure that any spilled

fuel has been wiped up before starting the generator.

3. USE

BEFORE STARTING THE GENERATOR

Fill and check fuel level 2

Important. Only use a two-stroke mixture, in other words

unleaded petrol (octane level 92 and more) and two-stroke

oil mixed at a ratio of 50:1 (2%) to fuel the generator.

• Remove any power cords

• Turn power switches off

• Do not over ll – leave air gap at top of fuel level

• Always screw down fuel cap

• Clean up any spilled fuel

• Do not smoke while operating the generator

Always use caution!

Starting the generator 1

1. Turn on fuel tap (10).

2. Turn on engine switch (2).

3. Move choke lever (3) to closed position (to restart a

warm engine, leave the choke lever in open or half-

open position).

4. Pull slowly on the starter cord until it engages, then pull

sharply to start the engine (4).

5. Allow the engine to run until it warms up, and then move

the choke lever to the open position (3).

6. Plug in the power cord.

Stopping the generator 1

1. Unplug all cords

2. Turn engine switch to «OFF» (2)

3. Turn off fuel tap (10)

The generator is equipped with DC output (12 V / 5 A) that

allows to charge batteries through the cable supplied. Ob-

serve polarity (red lead to +, black lead to -).

4. SERVICE & MAINTENANCE

PERIODIC MAINTENANCE

Daily (pre-operation check)

• Check choke operation

• Check recoil starter operation

3 Months or 50 hrs

• Check condition of spark plug. Adjust gap and clean.

Replace if necessary.

• Clean, replace if necessary.

6 Months or 100 hrs

• Clean fuel tap and fuel tank  lter. Replace if neces-

sary.

• Check  ttings and fasteners. Replace if necessary.

SERVICE – NOTES ON MAINTENANCE

Spark plug inspection 3

• Disconnect the spark plug cap, and remove any dirt

from around the spark plug area.

• Remove spark plug (11) with the plug spanner sup-

plied.

• Inspect the spark plug. It should be a tan colour.

• Measure the gap (distance contact point) with a suit-

able gauge. The gap should be 0.7-0.8 mm. Correct

the gap, if necessary, by carefully bending the side

electrode.

• Replace the spark plug if the electrodes are worn, or if

the insulator is cracked or chipped.

• Install the spark plug carefully, by hand, to avoid cross-

threading.

• Place the spark plug with correct torque: 20 Nm.

• Attach the spark plug cap.

Exhaust screen

• Wait for exhaust to cool.

• Exhaust screen (9) may be blocked up with carbon de-

posits.

• Undo the screw cap and remove the exhaust screen.

• Clean the screen with a wire brush and re t.

• Replace exhaust screen if damaged.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Defort DGI-800 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info