Bedienungsanleitung Defort DGI-800 (Seite 8 von 88) (Alle Sprachen)

555813

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

Air  lter cleaning

• Unscrew the air  lter cover (12).

• Remove  lter element and wash well in solvent.

• Pour a small amount of oil onto the  lter element and

gently squeeze out any excess oil.

• Replace the  lter element and air  lter cover.

• Be sure the  lter cover seals properly all around.

Do not run the engine without the air  lter element

in place.

Never place a wet  lter (with solvent) on the

machine.

Fuel tap

• To remove the fuel tap  lter, simply undo the cup at the

bottom of the fuel tank

• Use a small spanner to remove the tap

• Clean and wash out the  lter and cup, and replace.

TROUBLESHOOTING

Basic checks

• Make sure you have plenty of fuel

• Make sure the fuel tap is on

• Make sure the engine-switch is on

• Remove spark plug, connect spark plug lead and earth

it to the generator. Pull starter cord gently and look for

a spark. If there is no spark, replace spark plug.

Spark plug is OK, but engine still won’t start

• Check fuel tap  lter is clean

• Check fuel line is clear

• Check carburetor is not clogged

Engine will not start

• Clean or replace spark plug

• Check ignition system – if faulty, contact your service

centre.

• Check compression – if low, contact your service cen-

tre

• Check for loose cylinder head – tighten bolts

• Check for damaged cylinder head gasket – replace if

necessary

CLEANING

Clean the housing regularly with a soft cloth, preferably

every time it is used. Keep the air vents free of dust and

dirt.

Remove stubborn dirt with a soft rag moistened in soapy

water. Do not use any solvents such as petrol, alcohol,

ammonia, etc. as such substances can damage the plastic

parts.

STORAGE (LONG TERM)

• Drain fuel tank, fuel tap, carburetor bowl and carbure-

tor

• Pour 1 cup of engine oil into the fuel tank and shake

the generator to spread the oil around the tank. Drain

excess oil.

• Remove spark plug and pour in 1 spoonful of engine

oil, pull the starter cord several times with the starter

switch OFF. Replace spark plug.

• Pull on the starter cord until you feel compression and

stop.

• Clean the generators exterior and coat with rust inhibi-

tor.

• Place the generator on  at ground and cover with a

clean dry cloth.

FAULTS

If a fault arises through wear in an element, please contact

the service address shown on the warranty card.

A drawing of the spare parts that may be obtained is in-

cluded at the end of these operating instructions.

ENVIRONMENT

To prevent damage during transport, the appliance is

delivered in a solid packaging which consists largely of

reusable material. Therefore please make use of options

for recycling the packaging.

WARRANTY

Read the terms of warranty on the separate warranty card

which is enclosed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Defort DGI-800 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info