Bedienungsanleitung DeLonghi Dinamica Plus - ECAM380.95 (Seite 18 von 28) (Englisch)

821516

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

set intervals to remove the scale residues from inside the

coee machine;

After about 15 minutes, descaling stops;

10. "RINSE AND FILL WATER TANK UP TO MAX LEVEL" (g. 3):

the appliance is now ready for a process of rinsing with

fresh water. Empty the container used to collect the des-

caler solution. Remove the water tank from the machine,

empty it and rinse under running water, then ll with clean

water up to the MAX level and reposition it in the machine.

11. "POSITION 2l CONTAINER OK TO START RINSING": Repo-

sition the container used to collect the descaler solution,

empty, under the coee spouts and hot water spout and

press ;

12. Hot water is delivered rst from the coee spouts then

from the hot water spout and the message "RINSING UN-

DERWAY, PLEASE WAIT" is displayed;

13. When the water in the tank has run out, empty the con-

tainer used to collect the rinsing water;

14. (If the lter is installed) "INSERT FILTER IN ITS HOUSING"

(g. 36). Press and take out the water tank:

replace the water softener lter, if removed previously;

15. "RINSE AND FILL WATER TANK UP TO MAX LEVEL" (g. 3): Fill

the tank up to the MAX level with fresh water;

16. "INSERT WATER TANK" (g. 4): Reposition the water tank

in the machine.

17. "POSITION 2l CONTAINER" "OK TO START RINSING": Repo-

sition the container used to collect the descaler solution,

empty, under the hot water spout (g. 8) and press

18. Hot water is delivered from the hot water/steam spout

and the message "RINSING UNDERWAY, PLEASE WAIT" is

displayed;

19. "EMPTY DRIP TRAY" (g. 21): At the end of the second

rinse, empty the container used to collect the rinsing

water, remove and empty the drip tray (A15) and grounds

container (A11) and return them to the machine: press

;

20. "DESCALE COMPLETE": press ;

21. "FILL TANK WITH FRESH WATER": remove and top up the

water tank with fresh water to the MAX level and put back

in the machine.

The descaling cycle is now complete.

Please note!

• If the descaling cycle is not completed correctly (e.g. elec-

trical power failure), when power is restored the appliance

will prompt for the cycle to be completed.

• Water may nd its way into the grounds container (A11)

during the descale cycle: this is quite normal.

• If the water tank has not been lled to the MAX level, at

the end of descaling, the appliance requests a third rinse to

guarantee that the descaler solution has been complete-

ly eliminated from the machine's internal circuits. Before

starting the rinse, remember to empty the drip tray.

14.

SETTING WATER HARDNESS

The descaling alert is displayed after a period of operation es-

tablished according to water hardness.

The machine can also be programmed according to the actual

hardness of the local water supply, so that the descaling proce-

dure will be required less frequently.

14.1 Measuring water hardness

1. Remove the "TOTAL HARDNESS TEST" indicator strip (D1)

from its pack.

2. Immerse the paper completely in a glass of water for about

one second.

3. Remove the strip from the water and shake lightly. After

about a minute, 1, 2, 3, or 4 red squares appear, depending

on the hardness of the water. Each square corresponds to

one level.

14.2 Setting water hardness

1. Access the menu as described in section "6.1 Access the

menu";

2. Press "WATER HARDNESS";

3. Carry out the procedure described in the previous section

to measure the water hardness;

4. "WATER HARDNESS" "CURRENT VALUE UNDERLINED": Press

the level measured previously as indicated in the following

table: (Level 1 = soft water; Level 4 = very hard water);

Indicator paper Water hardness

Level 1 - soft water

Level 2 - slightly hard

water

Level 3 - hard water

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi Dinamica Plus - ECAM380.95 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi Dinamica Plus - ECAM380.95

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info