Bedienungsanleitung DeLonghi Dinamica Plus - ECAM380.95 (Seite 19 von 28) (Englisch)

821516

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Indicator paper Water hardness

Level 4 - very hard water

5. Press to go back to the homepage.

The machine is now reprogrammed with the new water hard-

ness setting.

15. WATER SOFTENER FILTER

Certain models come equipped with a water softener lter (D4):

if this is not the case with your model, we would advise pur-

chasing one from a De’Longhi approved service centre. To use

the lter correctly, follow the instructions below.

15.1 Installing the lter

1. Access the menu as described in section "6.1 Access the

menu";

2. Press "WATER FILTER";

3. "TURN DATE INDICATOR TO NEXT 2 MONTHS" (g. 37): re-

move the new lter (D4) from the pack and turn the date

indicator disk so that it shows the next 2 months of use.

Press ;

37 38

Please note

IThe lter lasts about two months assuming normal use of the

machine; if on the other hand the machine remains idle with the

lter installed, it will not last more than three weeks, at most.

4. "RUN WATER INTO FILTER HOLE" "UNTIL IT COMES OUT" (g.

38): To activate the lter, run tap water through the central

hole of the lter as shown in the gure until water comes

out of the openings at the side for more than one minute.

Press ;

5. Extract the tank (A17) from the appliance and ll with

water.

6. "IMMERSE FILTER TO RELEASE AIR BUBBLES" (g. 39): In-

sert the lter in the water tank and immerse it completely

for about ten seconds, tilting it and applying light pressure

so that the air bubbles can escape.

Press ;

7. "INSERT FILTER" "IN HOUSING": Insert the lter (D4) in

the lter housing (g. 36) and press fully home. Press

;

8. "INSERT WATER TANK": Close the tank with the lid (A16),

then reposition the tank in the machine (g. 4);

9. "POSITION 0.5L CONTAINER, OK TO ENABLE FILTER" (g.

6): Place the container under the hot water spout (D6) and

press

: "HOT WATER PLEASE WAIT" delivery

starts and stops automatically.

The lter is now activated and the machine can be used.

15.2 Replacing the lter

Replace the lter (D4) when "REPLACE WATER FILTER" "PRESS

OK TO START" appears on the display: to replace immediately,

press

and follow the instructions from point 5 of

the preceding section.

To delay replacement of the lter until later, press .

The symbol (B8) appears on the display as a reminder that

the lter needs replacing. To replace, proceed as follows:

1. Access the menu as described in section "6.1 Access the

menu";

2. Press "WATER FILTER";

3. Press "REPLACE FILTER"

4. First remove the tank (A17) and the spent lter, then fol-

low the operations described in the previous section from

point 3 onwards.

Please note!

After two months (see date indicator), or after 3 weeks if the

appliance has not been used, the lter should be replaced even

if the warning message has not yet been displayed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi Dinamica Plus - ECAM380.95 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi Dinamica Plus - ECAM380.95

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info