Bedienungsanleitung DeLonghi ECAM550.65 Prima Donna Class (Seite 11 von 20) (Englisch)

770029

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

4. (Models with water softener lter only) Deliver about

100ml of hot water to reactivate the lter.

12.7 Cleaning the coee spouts

1. Clean the coee spouts (A8) regularly with a sponge or

cloth (g. 25A);

2. Check that the holes in the coee spouts are not blocked.

If necessary, remove coee deposits with a toothpick (g.

25B).

12.8 Cleaning the pre-ground coee funnel

Check regularly (about once a month) that the pre-ground

coee funnel (A4) is not blocked. If necessary, remove coee

deposits with the brush (C5) supplied.

12.9 Cleaning the infuser

The infuser (A19) must be cleaned at least once a month.

Important!

The infuser may not be extracted when the machine is on.

1. Make sure the machine is correctly turned o (see section

“5. Turning the appliance o”);

2. Remove the water tank (A16) (g. 2);

3. Open the infuser door (A18) (g. 26) on the right side of

the appliance;

4. Press the two coloured release buttons inwards and at the

same time pull the infuser outwards (g. 27);

5. Soak the infuser in water for about 5 minutes, then rinse

under the tap;

Important!

RINSE WITH WATER ONLY

NO WASHING UP LIQUID  NO DISH WASHER

Clean the infuser without using washing up liquid as it

could be damaged.

6. Use the brush (C5) to remove any coee residues left in the

infuser housing, visible through the infuser door;

7. After cleaning, replace the infuser by sliding it onto the

internal support (g. 28), then push the PUSH symbol fully

in until it clicks into place;

Please note!

If the infuser is dicult to insert, before insertion, adapt it to the

right size by pressing the two levers shown in g. 29.

8. Once inserted, make sure the two coloured buttons have

snapped out (g. 30);

9. Close the infuser door;

10. Put the water tank back.

12.10 Cleaning the milk container

To keep the frother ecient, clean the milk container (D) every

two days as described below:

1. Remove the lid (D2);

2. Remove the milk spout (D5) and intake tube (D4) (g. 32);

3. Turn the froth adjustment dial (D1) anticlockwise to the

"INSERT" position (g. 32) and pull o upwards;

4. Wash all the components thoroughly with hot water and

mild washing-up liquid. All components are dish-

washer safe, placing them in the top basket of the

dishwasher.

Make sure there are no milk residues on the hollow and

groove under the dial (g. 31). If necessary, scrape the

groove with a toothpick;

5. Rinse inside the froth

adjustment dial seat with

running water (g. 33);

6. Check that the intake

tube and spout are

not clogged with milk

residues;

7. Replace the dial (in cor-

respondence to the word

"INSERT"), spout and

milk intake tube;

8. Place the lid back on the

milk container (D3).

12.11 Cleaning the hot water/steam connection

nozzle

Each time you prepare milk, clean the connection nozzle (A9)

with a sponge to remove milk residues from the gaskets (g.

21).

13. DESCALING

Important!

• Before use, read the instructions and the labelling on the

descaler pack.

• You should use De’Longhi descaler only. Using unsuitable

descaler and/or performing descaling incorrectly may re-

sult in faults not covered by the manufacturer's guarantee.

Descale the appliance when "DESCALING NEEDED - PRESS OK TO

START (~45min) " appears on the display (B1): To descale

the appliance immediately, press the corresponding selector

(B2) " OK" and follow the instructions from point 3.

To descale the appliance later, press the selector (B2) corre-

sponding to " ESC". The symbol appears on the display

to remind you that the appliance needs descaling. (the message

appears each time you turn the appliance on).

To access the descaling menu:

After about 25 minutes, descaling stops;

"RINSE AND FILL WATER TANK UP TO MAX LEVEL" (g. 4): the

appliance is now ready to rinse with fresh water. Empty the

container used to collect the descaler solution. Extract the

water tank, empty, rinse under running water, ll with fresh

water up to the MAX level and put back in the appliance;

9. "POSITION 2l CONTAINER PRESS OK TO START RINSING":

Place the container used to collect the descaler solution

empty under the coee spouts and hot water spout (g. 8)

and press the selector corresponding to " OK";

10 Hot water is delivered rst from the coee spouts, then

from the hot water spout and "RINSING UNDERWAY" is

displayed;

11. When the water in the tank has run out, empty the con-

tainer used to collect the rinsing water;

12. (If the lter is installed)

"INSERT FILTER INTO

ITS HOUSING" (g. 37).

Press the selector cor-

responding to "NEXT>"

and extract the water

tank. Replace the water

softener lter if removed

previously;

13.

"RINSE AND FILL WATER

TANK UP TO MAX LEVEL"

(g. 4): Fill the tank up to

the MAX level with fresh

water;

14. "INSERT WATER TANK" (g. 5): Put the water tank back in

the appliance;

15.

"POSITION 2l CONTAINER PRESS OK TO START RINSING":

Place the container used to collect the descaler solution

empty under the hot water spout (g. 7) and press the

selector corresponding to " OK";

16. Hot water is delivered from the hot water spout and "RINS-

ING UNDERWAY, PLEASE WAIT" is displayed;

17. "EMPTY DRIP TRAY" (g. 36): At the end of the second

rinse, remove, empty and replace the drip tray (A14) and

grounds container (A10). Press the selector corresponding

to "NEXT>";

18. "DESCALE COMPLETE": to conrm, press the selector corre-

sponding to “ OK";

19. "FILL TANK WITH FRESH WATER": empty the container

used to collect the rinse water, remove the water tank and

ll with fresh water up to the MAX level, then put back in

the appliance.

Descaling is complete.

A B

DeLonghi ECAM550.65 Prima Donna Class Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi ECAM550.65 Prima Donna Class

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info