C ollection
29
NOTE 3: When dosing the quantity of coffee to be added, use the measure supplied only.
NOTE 4: Use ground coffee for espresso coffee makers only. Do not use coffee beans, freeze-dried coffee or
other materials that could damage the appliance.
NOTE 5: If you add more than one measure of ground coffee and the funnel blocks, use a knife to push the cof-
fee down (fig. 16), then remove and clean the infuser and appliance as described in section 16.2 "Cleaning the
infuser".
10 PRODUCING HOT WATER
•Always make sure the appliance is ready..
•Make sure the hot water spout is attached to the nozzle (fig. 4);
•Position a container under the spout (fig. 3).
•Press the button (fig. 17).
The appliance displays:
HOT WATER
and hot water is run off from the water spout into the container below (you should not run off hot water
for more than two minutes at a time). To stop the flow, press the . button. Once the set quantity of hot
water has been reached, run-off stops automatically.
11 CHANGING THE QUANTITY OF HOT WATER
The appliance is factory preset to automatically deliver 250 ml of hot water. To change these quantities, pro-
ceed as follows:
•Make sure the water spout is in place (fig. 4).
•Position a container under the spout (fig. 3).
•Press the button (fig. 17) for at least 8 seconds until you hear a “BEEP”, then release the button.
The appliance displays:
HOT WATER PROGRAM QUANTITY
and hot water is run off from the water spout.
•When the hot water in the cup reaches the required level, press the button to memorise the new
amount. The appliance emits a double “BEEP”.
(You should not run off hot water for more than two minutes at a time).
12 PREPARING CAPPUCCINOS (FROTHED MILK AND COFFEE)
•Select the taste of the coffee you want to use to make the cappuccino by pressing the OK button
(fig. 1).
•Remove the lid of the milk container.
•Fill the container with about 100 grams of milk for each cappuccino to be prepared (fig. 18).
Never exceed the MAX level (corresponding to about 800 ml) marked on the container.
You should preferably use skimmed or semi-skimmed milk at refrigerator temperature (about 5° C).
•Make sure the intake tube is correctly inserted in the bottom of the milk container lid (fig. 19), then repla-
ce the milk container lid and turn anticlockwise as far as it will go.
•Place the container pointer in position 1 (=CAPPUCCINO) (fig. 20). If the froth is not satisfactory, move the
pointer slightly until you obtain the required froth.
•Remove the hot water spout (fig 21) and attach the milk container to the nozze. You will hear a “BEEP” (fig. 22).
•Position the milk tube as shown in fig. 23 and then place a sufficiently large cup under the coffee and milk
spouts (fig. 23).
•Press the CAPPUCCINO button (fig. 24).
The button lights up and the appliance displays:
CAPPUCCINO: CONTAINER POINTER IN position 1
Make sure the milk container lid pointer is turned to the same number as the number displayed.
After a few seconds, the frothed milk is run off from the milk spout into the cup below.
Run off of milk stops automatically and run off of coffee begins.
