C ollection
31
•Once the required quantity of coffee has been run off, press the button selected previously. Coffee delivery
stops and the quantity is memorised.A double “BEEP”confirms that the new values have been memorised.
The appliance is now re-programmed with the new settings and displays: READY.
16 CLEANING AND MAINTENANCE
Before performing any cleaning operations, the appliance must have cooled down and must be disconnected
from the mains power supply.
Never immerse the appliance in the water: it is an electrical appliance.
Do not use solvents, abrasive cleaning products or alcohol to clean the appliance. A soft damp cloth will suffi-
ce.No component may be washed in a dishwasher.
16.1 Cleaning the coffee maker
Clean the grounds container (as described in section 6, note 7) whenever it requires emptying.
The water tank should also be cleaned regularly.
The drip tray is fitted with a level indicator (red) showing the level of water it contains.
When the indicator starts to become visible (a few millimetres under the drip tray), the drip tray must be emp-
tied and cleaned.
Check that the holes in the coffee spout are not blocked.To unblock them, scrape the dry coffee residues away
with a needle (fig. 29).
Clean the nozzle after every use with a sponge as shown in fig. 30.
16.2 Cleaning the infuser
The infuser must be cleaned regularly to avoid the build-up of coffee encrustations which could cause mal-
function. Proceed as follows:
• turn the appliance off by pressing the button (fig. 6) (do not unplug) and wait for the display to go off;
•open the service door (Fig. 13);
•remove the drip tray and the grounds container (Fig. 14) and clean them;
•press the two red release buttons on the infuser sideways and towards the centre (Fig. 31) and pull it out;
• IMPORTANT: THE INFUSER CAN ONLY BE REMOVED IF THE APPLIANCE IS OFF.
AT TEMPTING TO REMOVE THE INFUSER WITH THE APPLIANCE ON MAY CAUSE SERIOUS DAMAGE.
•wash the infuser under running water, without using detergents. Never wash the infuser in the dishwasher;
•carefully clean the inside of the appliance. To remove the coffee stuck to the parts inside the appliance,
scrape it with a plastic or wooden fork and then pick up all the residues using a vacuum cleaner (Fig. 32);
•replace the infuser by sliding it onto the supports and pin at the bottom, then push the PUSH symbol fully
in until it clicks into place.
Support
Pin
Infuser
Push the PUSH symbol fully in until
it clicks into place.
After having heard the click, check
that the red buttons have snapped
out.
Bottom pipe on the infuser.
The pin must be inserted into the bottom pipe on the
infuser.
