133693
31
Zoom out
Zoom in
Vorherige Seite
1/92
Nächste Seite
SINGLE SPLIT
11
ENGLISH
HANDLING
The outdoor unit must always be kept upright.
Handling must be done by suitably equipped qualified
technical personnel using equipment that is suitable for
the weight of the appliance.
Carefully remove the adhesive strips from the appliance.
After having removed the packaging, check that the con-
tents are intact and complete.
INSTALLING THE INDOOR UNIT
USER
USER
Before starting installation, decide on the position of the
indoor and outdoor units, taking into account the mini-
mum clearance required around the units (see technical
data table).
Install the indoor unit in the room to be air conditio-
ned, avoiding installations in corridors or communal
areas.
Ensure that there is a mains socket very close to the
indoor unit where it can be plugged in.
Install the indoor unit at a height of at least 2.5 m
from the ground.
LOCATING THE INDOOR UNIT
The indoor unit must be wall mounted.
It must be located so that the treated air can circula-
te throughout the room.
To install the indoor unit proceed as follows:
Installing the mounting plate
- Remove the screws from the plate, which is attached to
the rear of the unit.
- Remove the plate;
- Place it against the wall at the point where it is to be
installed, using a spirit level (provided in the kit) to
ensure that it is horizontal and complying with the mini-
mum clearance indicated in the figure.
- Using a pencil, mark the position of the holes for the
screw anchors on the wall.
- Drill 32 mm deep holes in the wall for fixing the plate.
- Insert the plastic anchors into the hole.
- Fix the mounting plate to the wall using the anchors
and the self-tapping screws provided in the kit.
- Check that the mounting plate is correctly fixed.
- Check again that the plate is level.
Drilling a hole in the wall for the piping
- Decide where to drill the hole in the wall for the piping
according to the position of the mounting plate (see
figure)
- Using compasses, mark the circumference (ø 90 mm) of
the hole for the connections to pass through.
The hole must be drilled in the left side of the unit in
line with the refrigerant outlet connections.
Note: when the product is delivered the mounting plate
is attached to the rear of the indoor unit. It may be a dif-
ferent shape to the one shown above, but the method of
installation is the same.
150 mm
150 mm150 mm
4,1 x 32
4,1x32
Mounting
plate
Plastic anchor
Outline of the unit
Recommended minimum clearance
(Ø 90 mm)
Plate (wall-
mounted)
31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für DeLonghi pls 120 ar wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info