8
Timer function
This function can be activated during any operating mode. The timer can be used to program
the time the appliance remains in operation, from 1 to 8 hours.
Each time you press the button (E), the operating time increases by one hour.
When the timer has been set, the time decreases in steps of one hour and the time remaining is
displayed. At the end of the set time the appliance goes off.
If you do not want to use the appliance with the timer, when the display shows 8 hours, press
the button (E) again to return to manual operation.
Frost prevention mode
You can keep the room at a temperature of around 5°C to prevent the room from freezing, with
minimal energy consumption.
Press the MODE button (G) until AUTO is displayed. Press the button “-” to select a temperature
set point of (5°C). When the room temperature drops below the set temperature, the
appliance comes on automatically.
USING THE REMOTE CONTROL
The remote control should be handled with care, so avoid dropping it and never let it get wet
1. Press the STAND-BY button (H).
2. To use the oscillate (I), SET TIME (E), MODE (G) and temperature adjustment (F) buttons, see
the “OPERATION AND USE” section.
3.
To replace the batteries, remove the cover on the back of the remote control unit.
The remote control uses two AAA type alkaline batteries (included but packaged separately).
4. Do not mix used and new batteries with different values.
MAINTENANCE
- Always unplug the heater before cleaning.
- During the season when the appliance is in use, clean the air intake and exhaust grilles
regularly using a vacuum cleaner.
- Never use abrasive powders or solvents.
Warnings
-Do not use this heater near showers, bathtubs, sinks, swimming pools, etc.
- Always use the heater in an upright position.
-
Do not use the heater to dry laundry. Never obstruct the intake and outlet grilles (danger of overheating).
- The appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the applian-
ce.
- The heater must be positioned at least 50 cm from furniture or other objects.
- Do not use the appliance near walls, furniture, curtains, etc.
- The use of extension leads is not recommended. However if they cannot be avoided, follow
the instructions accompanying the extension lead and never exceed the power limit marked
on the extension.
- CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout,
this appliance must not be supplied through an external switching device, such as a timer,
or connected to a circuit that is regularly switched on and off by the utility.
- If the power cable is damaged, it must be replaced by the manufacturer, an authorised ser-
vice centre or a qualified electrician in order to eliminate all risk.
- The appliance must not be positioned directly underneath a fixed power point.
- Do not use the appliance in rooms with a floor area of less than 4 m
2
.
- The appliance is fitted with a tip-over switch which turns the appliance off if it falls over.
To restart the appliance, simply place it upright again.
- When you turn the appliance on for the first time, operate it at maximum for at least two
hours. During this time, you should ventilate the room to eliminate the “new” smell given
off. It is normal for the appliance to make "squeaking" noises when first turned on.
