1Only the front speakers (A) is measured.
Even if the front speakers (B) is set, the setting automatically switches to the front speakers (A) once
measurements are completed.
2 Subwoofer speaker is measured twice.
After each channel is measured, “Calculating” appears.
The display switches to Auto Setup check screen automatically.
NOTES:
• Measurement is canceled when MASTER
VOLUME is operated while the Auto Setup is
performed.
• Set the volume to halfway and set the crossover
frequency to the maximum or low pass filter off
if your subwoofer can adjust the output volume
and the crossover frequency.
About automatic retry
Remeasurement starts automatically to receive proper result of measurement.
Remeasurement is performed to 2 times, and “Retry1” or “Retry2” is displayed
on screen during remeasurement.
About the error message
These error screens will be displayed when performing the measurements of Auto Setup and the automatic
measurements can not be completed because of the speaker arrangement, measurement environment, or other
factors. Please check the following matters, reset the pertinent items, and measure again.
When there is too much noise in the room, the speakers may not be detected properly. Should this happen,
perform the measurements when the noise level is low, or switch off the power of the equipment that is
producing the noise for the duration of the measurements.
q This screen will be displayed when the speakers
required for producing suitable reproduction have
not been detected.
• The front L and front R speakers were not
properly detected.
• Only one channel of the surround speakers was
detected.
• Sound was output from the R channel when
only one surround back speaker was connected.
• The surround back was detected, but the
surround speaker was not detected.
Check that the pertinent speakers are properly
connected. (see page 9)
w This screen will be displayed when the speaker
polarity is connected in reverse.
Check the polarity of the pertinent speakers.
For some speakers, the screen below may be
displayed even though the speakers are
properly connected. If so, select “Skip
0”.
e This screen will be displayed when accurate
measurements cannot be made due to the input
level to the microphone being too high.
Set up the speakers so that their position is
farther away from the listening position.
Lower the volume of the subwoofer.
r This screen will be displayed when the
measurement microphone is not connected, or
when all of the speakers have not been detected.
Connect the measurement microphone to the
microphone connector.
Check the speaker connections.
