Bedienungsanleitung DeWalt DW 152 (Seite 26 von 112) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

78842

Zoom out

Zoom in

Vorherige Seite

1/112

Nächste Seite

ENGLISH

Follow the fitting instructions supplied with good

quality plugs. Recommended fuse: 13 A.

Using an Extension Cable

If an extension cable is required, use an approved

3–core extension cable suitable for the power

input of this tool (see technical data).The minimum

conductor size is 1.5 mm

; the maximum length is

30 m.

When using a cable reel, always unwind the cable

completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of

injury, turn unit off and disconnect

machine from power source before

installing and removing accessories,

before adjusting or changing set-

ups or when making repairs. Be sure

the trigger switch is in the OFF position.

An accidental start-up can cause injury.

WARNING: Prior to assembly and

adjustment always unplug the tool.

Inserting and Removing an

Accessory (ﬁ g. 1)

This tool uses morse taper type accessories.

1. Insert the tapered shank into the tool holder (g).

The accessory will be automatically locked in

position.

2. To remove the accessory insert the drift wedge

(h) into the drift wedge slot (i) and strike it with a

hammer. The drift wedge can be stored in the

hollow housing of the threaded side handle (e).

Side Handles (ﬁ g. 2)

The tool is equipped with two removable side

handles (e, f) to operate the drill when it is used as a

hand-held tool.

FITTING THE THREADED SIDE HANDLE

Screw the handle (e) into position and tighten it.

FITTING THE CONTROL SIDE HANDLE

Mount the handle (f) onto the gear housing (j) using

the four hexagonal screws (m) provided.

Mounting the Breast Plate (ﬁ g. 2)

The breast plate (k) enables optimal control of the

drill when it is used as a hand-held tool.

Mount the breast plate (k) to the rear end of the tool

using the fixing bolt (n) provided.

WARNING: When using the drill as a

hand-held tool always make sure that

the side handles and breast plate are

properly assembled.

Forward/reverse Slider (ﬁ g. 1)

The forward/reverse action in both gears enables the

tool to be used for e.g. thread tapping.

To select forward or reverse rotation use the forward/

reverse-switch (b).

– R (Right): forward rotation

– L (Left): reverse rotation

WARNING: The direction of rotation

must only be changed when the motor

has come to a complete standstill. A

safety device prevents any change of

rotation if the motor is still switched on.

Two-gear Selector (ﬁ g. 3)

The tool is fitted with a two gear selector (c) to vary

the speed/torque ratio.

• Release the on/off switch and select the

required position after the motor has come to a

complete standstill.

Position Speed/torque ratio Application

I Low speed/high torque Drilling large holes

II High speed/low torque Drilling smaller holes

For speed rates, refer to the technical data.

WARNING: Do not try to change gears

at full speed or under load.

Mounting the drill onto a drill stand. Your drill can be

mounted on a drill stand (optional) for stationary use.

1. Remove the breast plate by loosening the fixing

bolt.

2. Remove both side handles.

3. Mount the tool onto the drill stand. Make sure

to tighten all fixing bolts provided with the drill

stand.

OPERATION

WARNING: To reduce the risk

of serious personal injury, turn

tool off and disconnect tool from

power source before making any

adjustments or removing/installing

attachments or accessories.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeWalt DW 152 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info