Bedienungsanleitung Dimplex Moorefield (Seite 24 von 46) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

706516

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

Additional Information

AFTER SALES SERVICE

Your product is guaranteed for two years from the date of purchase. Within this period, we undertake to repair or

exchange this product free of charge (excluding lamps & subject to availability) provided it has been installed and

operated in accordance with these instructions. Your rights under this guarantee are additional to your statutory rights,

which in turn are not affected by this guarantee.

Should you require after sales information or assistance with this product please go to warrenty card at back of

the book where you can ring our help desk. Spare parts are also available. Please retain your receipt as proof of

purchase.

RECYCLING

For electrical products sold within the European Community - At the end of the electrical products useful life

it not be disposed of with household waste. Please recycle where facilities exist. Check with your Local

Authority or retailer for recycling advice in your country.

PATENT / PATENT APPLICATION

Products within the Optimyst range are protected by one or more of the following patents and patent applications:

Great Britain GB 2402206, GB 2460259, GB 2460453 , GB 2418014, GB 2465738, GB 2449925, GB 2465537 , GB

2455277 , GB1020534.2, GB1020537.5, GB1110987.3

United States US 7967690, US 2010299980, US 2011062250, US 2008028648, US 13/167,042

Russia RU2008140317

European EP 2029941, EP 2201301, EP 2315976, EP 1787063, EP07723217.1 , EP11170434.2, EP 11170435.9

China CN 101883953, CN 200980128666.2, CN 101057105, CN 101438104

Australia AU 2009248743, AU 2007224634

Canada CA 2725214, CA 2579444, CA 2645939

International Patent Application WO 2006027272

South Africa ZA 200808702

For general cleaning use a soft clean duster – never use abrasive cleaners.

To remove any accumulation of dust or uff the soft brush attachment of a vacuum cleaner should occasionally be used

to clean the outlet grille of the fan heater.

Water tank

1. Remove water tank, as described earlier, put into sink and empty water.

2. Using the supplied brush gently rub the inside surfaces of the cap paying particular attention to the rubber ring in

the outer groove and the centre rubber seal.

3. Put a small quantity of washing up liquid into the tank, ret the cap and shake well, rinse out until all traces of washing

up liquid are gone.

4. Rell with decalcied tap water only, replace the cap, do not overtighten.

Sump

1. Press Switch ‘A’ to the ‘OFF’ (0) position

2. Gently lift out the fuelbed and place carefully on the ground.

3. Remove the water tank by lifting upwards.

4. Disconnect the electrical connector, located on the right side of the sump. (Fig.5) .

5. Release the right sump locking tabs by turning 90º. This allows the sump to be lifted completely from its location. (Fig.

11)

6. Gently lift up the sump, taking care to keep level so as not to spill any water. Sit the assembly in the sink.

7. Release the left sump locking tabs by turning 90º, then lift off the Nozzle. (Fig.3)

8. Lift out the transducer and carefully tilt, as shown, so that the liquid drains out of the sump. (Fig.13)

9. Put a small amount of washing up liquid into the sump, and using the supplied brush, gently clean all surfaces in the

sump and gently clean the transducer including the metal discs located in the top grooved surface. (Fig.14)

10. When cleaned, thoroughly rinse the sump with clean water to remove all traces of washing up liquid.

11. Clean the Nozzle with the brush and ush out thoroughly with water. (Fig.15)

12. Reverse the above steps to reassemble.

Air lter

1. Gently lift out the fuelbed and place carefully on the ground.

2. Gently slide the air lter upwards out of its plastic holder. (Fig.16)

3. Gently rinse with water in the sink and dry with fabric towel before returning.

4. Replace the lter making sure that the coarse black lter is facing the front of the re.

5. Replace the fuelbed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dimplex Moorefield Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Dimplex Moorefield

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info