Bedienungsanleitung Dirt Devil M 5080 - EQU Turbo Silence (Seite 17 von 30) (Deutsch, Englisch, Französisch)

500166

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

5 Maintenance

5.3 Cleaning the dual motor protection filter

 It is best to check/clean the dual motor protection filter each time you

clean the dust container and cyclone unit, Chapter 5.2, "Cleaning the

dust container and cyclone unit".

 Clean the dual motor protection filter at the latest when the cleaning in-

dicator (Fig. 12/A1) flashes red.

1. Release the retaining clip on the cover as shown (Fig. 12/B) and open

the cover.

2. Remove the dual motor protection filter (Fig. 12/C).

3. Hold the dual motor protection filter low over a dustbin. Separate the fil-

ter elements from one another (Fig. 13/A). Remove larger agglomera-

tions of dirt by hand.

4. If the filter elements are still dirty, thoroughly rinse them by hand until

all dirt is gone.

5. If one of the filter elements is damaged, replace it with a new one

(Chapter 6.2, "Spare parts and accessories").

6. Put the completely dry filter elements back together again.

7. Put the dual motor protection filter back onto the cyclone unit (Fig. 13/

B).

8. Put the cover back on. Lock the cover by pushing it firmly onto the cy-

clone unit (Fig. 13/C) until the retaining clip clicks into place.

5.4 Cleaning the hygienic exhaust filter

 It is best to check/clean the hygienic exhaust filter each time you clean

the dual motor protection filter, Chapter 5.3, "Cleaning the dual motor

protection filter".

1. Switch off the appliance, Chapter 4.3, "Switching off".

2. Slide the release catch of the exhaust filter cover to the right (Fig. 14/A)

and open the exhaust filter cover.

3. Remove the hygienic exhaust filter (Fig. 14/B).

4. Tap the dirt out of the hygienic exhaust filter over a dustbin.

5. Remove residual dust with a soft brush, e.g. the supplied furniture

brush.

6. If the hygienic exhaust filter is still dirty after this procedure, thoroughly

rinse it by hand until all dirt is gone.

7. If the exhaust filter is damaged or deformed, replace it (ordering infor-

mation Chapter 6.2, "Spare parts and accessories").

8. Place the clean/new exhaust filter back into its receptacle (Fig. 15/A).

9. Fit the exhaust filter cover on the bottom first and then pivot it in up-

wards into place (Fig. 15/B).

ABC

ATTENTION:

The filter elements are washable, but may not be cleaned in dishwash-

ers or washing-machines. Also, do not use detergents or brushes with

hard bristles to clean them. Let the filters dry for approx 24 hours at

room temperature after cleaning. Only put them back into the appliance

when they are completely dry.

ATTENTION:

The filter is washable, but it may not be cleaned in dishwashers or wash-

ing machines. Also, do not use detergents or brushes with hard bristles

to clean them. Let the filter dry for approx. 24 hours at room temperature

after washing it. Only put it back in place when it is completely dry.

M5080.book Seite 17 Dienstag, 24. April 2012 10:48 10

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dirt Devil M 5080 - EQU Turbo Silence Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info