Bedienungsanleitung Dirt Devil M2827-2 Centec (Seite 7 von 38) (Deutsch, Englisch, Dänisch, Schwedisch, Finnisch)

571436

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

4 Operation

4.1 Operational safety

4.2 Vacuum cleaning

1. Pull out the cord by the plug up to the yellow mark (Fig. 6/1).

2. Insert the mains plug into a socket with ground/safety contact.

3. Switch on the cylinder vacuum cleaner with the on/off switch (Fig. 6/4).

4. Adjust the suction power with the suction power control (Fig. 6/5).

5. If using the floor nozzle, set the "carpet/hard floor" selector according

to the type of floor to be cleaned (Fig. 7/1):

for deep- and short-pile carpets, runners (Fig. 7/A)

for hard floors such as laminate, tiles, PVC etc. (Fig. 7/B).

4.3 Switching off

1. Switch off the cylinder vacuum cleaner with the on/off switch (Fig. 6/4)

and pull the plug from the mains socket.

2. Keep the plug in your hand.

3. To retract the power cord, push the cord retracting button (Fig. 6/3).

4.4 Transport and storage

 Only carry the vacuum cleaner by its carrying-handle (Fig. 8/1).

 For storage you can park the telescopic tube on the vacuum cleaner by

inserting the parking-hook of the floor nozzle into the parking-bracket

(Fig. 8).

 If you want to store the appliance for a longer period of time, empty the

dust container. Zchapter 5.1, „Emptying and cleaning the dust container“.

 Store the appliance in a cool, dry place, out of reach of children.

WARNING:

Danger of injury! Check appliance and power cord before each use. A

damaged appliance must never be used.

WARNING:

Danger of injury! Especially when vacuum-cleaning stairs make sure

that you always stand on a higher level than the appliance.

ATTENTION:

Only use the cylinder vacuum cleaner with all filters intact, in dry

condition and correctly fitted. Make sure that no objects obstruct the

telescopic tube, the suction hose or other openings.

NOTE:

Your cylinder vacuum cleaner is equipped with a safety switch to prevent

overheating. It will switch off automatically if overheated (e.g. due to

clogged suction channels).

If this happens:

 Switch off the vacuum cleaner.

 Pull the plug from the power socket.

 Remove the cause of the overheating.

 Wait for about 45 minutes.

After it has cooled off, you may switch on the vacuum cleaner again.

WARNING:

Danger of electric shock! If the red marking (Fig. 6/2) shows, press the

cord retracting button (Fig. 6/3) to pull in the cord up to the yellow mark

(Fig. 6/1) again. Otherwise, the power cord may be damaged.

NOTE:

With the bypass vent (Fig. 6/6) you can quickly reduce the suction power

if less power is needed, e.g. to release curtains accidentally sucked in.

WARNING:

Danger of injury! When leaving your working-area, switch off the

appliance and mind the notices at Zchapter 4.3, „Switching off“. This will

help avoid accidents.

WARNING:

Danger of injury! During uncontrolled retraction the power cord can whip

around, become an obstacle or overthrow objects. Therefore keep the

plug in your hand and guide it when retracting the power cord.

ATTENTION:

Never store the appliance next to heat sources (e.g. stoves or radiators).

Avoid exposing it to direct sunlight. Heat can damage the appliance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dirt Devil M2827-2 Centec Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Dirt Devil M2827-2 Centec

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info