Bedienungsanleitung Dirt Devil M3230 (Seite 15 von 24) (Deutsch, Englisch, Französisch)

500147

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

5 Maintenance

5.4 Cleaning the hygienic exhaust filter

 It is best to check/clean the hygienic exhaust filter each time you clean

the dual motor protection filter, ZChapter 5.3, "Cleaning the dual motor

protection filter".

1. Switch off the appliance, ZChapter 4.3, "Switching off".

2. Slide the release catch of the exhaust filter cover to the right (Fig. 13/A)

and open the exhaust filter cover.

3. Remove the hygienic exhaust filter (Fig. 13/B).

4. Tap the dirt out of the hygienic exhaust filter over a dustbin.

5. Remove residual dust with a soft brush, e.g. the supplied furniture

brush.

6. If the hygienic exhaust filter is still dirty after this procedure, thoroughly

rinse it by hand in running water until all dirt is gone.

7. If the exhaust filter is damaged, deformed or too soiled, replace it

(ordering information ZChapter 5.5, "Spare parts and accessories").

8. Place the clean/new exhaust filter back into its receptacle (Fig. 14/A).

9. Fit the exhaust filter cover on the bottom first and then pivot it in

upwards into place (Fig. 14/B).

5.5 Spare parts and accessories

 Ordering address: ZPage 48, "International Service"

 Further information: Z www.dirtdevil.de

 The adjacent accessory parts and spare parts can be reordered.

5.6 Before you send in the appliance

Before contacting your authorised Royal dealer, Royal service partner or

appliance market or sending in the appliance, first follow the procedure in

the following table to check if you can solve the problem yourself.

ATTENTION:

The filter is washable, but it may not be cleaned in dishwashers or

washing machines. Also, do not use detergents or brushes with hard

bristles to clean the filters. Let the filter dry for approx. 24 hours at room

temperature after washing it. Only put it back in place when it is

completely dry.

ATTENTION:

Only use original spare parts from the scope of delivery or those that you

have purchased by reordering.

Item number Description

2838001 Dual motor protection filter consisting of:

1 foam plastic filter element and 1 filter holder

2838002 1 hygienic exhaust filter

M203-5 1 parquet brush

M209 1 turbo brush

M219 1 mini turbo brush

M232 1 long, flexible crevice nozzle

WARNING:

Danger of injury! Never use a defective appliance! Always switch off the

appliance and disconnect it from the mains before starting troubleshoot-

ing ZChapter 4.3, "Switching off".

NOTE:

If you were unable to solve the problem with the information in the above

table, contact Customer Service (ZPage 48, "International Service").

Problem Solution

The appliance

will not start.

The socket does not carry current.

Test the vacuum cleaner at another socket which you

are sure carries current.

Power cord is damaged. Have the cord replaced by the

Royal Appliance Customer Service, address ZPage

48, "International Service".

The vacuum

cleaner stops

suddenly.

The overheating protection has tripped (possibly due

to blocked suction channels, filters, or similar).

Switch the appliance off and pull the plug out of the

socket. Remove the cause of overheating (e.g. by dis-

assembling telescopic tube and suction hose and re-

moving the obstacle and/or cleaning filters). Wait for

about 45 minutes. After the appliance has cooled off,

you may switch it on again.

The cleaning re-

sults are unsat-

isfactory in spite

of the appliance

working correct-

ly.

The bypass vent (Fig. 1/26) is open.

Close the bypass vent (Fig. 1/26).

The attached nozzle is unsuitable.

Change the nozzle, ZChapter 3.2, "Selecting the

proper nozzle".

The position of the "carpet/hard floor" selector (Fig. 1/

2) is unsuitable. Set the "carpet/hard floor" selector

(Fig. 1/2) to the correct position for the type of floor,

ZChapter 4.2, "Vacuum cleaning", step 4.

The dust container is full.

Empty the dust container, ZChapter 5.1, "Emptying

the dust container".

The filters are dirty. Clean the respective filter

ZChapter 5.2, "Cleaning the dust container and cy-

clone unit" or ZChapter 5.4, "Cleaning the hygienic ex-

haust filter".

When vacuum-

ing with the long,

flexible crevice

nozzle, there is

suddenly a high-

pitched whistling

and the suction

power drops

considerably.

The pressure in the vacuum cleaner became too low

and caused the safety valve to trigger.

Open the bypass vent until the valve no longer trig-

gers.

Problem Solution

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dirt Devil M3230 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Dirt Devil M3230

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info