Bedienungsanleitung DJI Inspire 1 RAW (Seite 83 von 85) (Englisch)

653252

Zoom out

Zoom in

Vorherige Seite

1/85

Nächste Seite

User Manual

INSPIRE RAW

FCC Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

Changes or modications not expressly roved by the party responsible for compliance could void the

user's authority to operate the equipment.

FCC Warning Message

Any Changes or modications not expressly roved by the party responsible for compliance could void the

user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the radiator&

your body. This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio or television reception,

Ensure there is only one rmware package le stored on your SD card.

Only storage devices that are formatted for FAT32 and exFAT le systems are supported for

aircraft and remote controller rmware updates.

Ensure the internet connection of your mobile device is stable when downloading the rmware

update package.

Turn on Airplane Mode on your mobile device before updating the rmware, as any incoming

calls may disrupt the update process.

Do not perform rmware update while the aircraft is still ying in the air. Only carry out rmware

update when the aircraft is landed.

Be sure to update the remote controller’s rmware to the latest version after you upgrade the

aircraft’s rmware.

The remote controller may become unlinked from the aircraft after updating. Re-link the remote

controller and aircraft.

Conrm the update results based on the blinking pattern of camera status indicator or gimbal

sound. It is normal for the aircraft to sound or the LED to blink during the update process.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DJI Inspire 1 RAW Seite 83

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info