Bedienungsanleitung Dovre Brut (Seite 34 von 153) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Norwegisch)

695929

Zoom out

Zoom in

Vorherige Seite

1/153

Nächste Seite

Controlling combustion air

The appliance has various features for air control; see

next figure.

09-20021-081

The primary air inlet regulates the air under the grate

(1).

The secondary air inlet regulates the air for the glass

(air wash) (2).

The back wall has permanent vents (3) below the

baffle plate that allow for post-combustion.

Advice

Never burn wood with an open door.

Regularly burn wood with intense roaring fires.

If you burn at a low setting frequently, tar and

creosote may be deposited in the flue. Tar and

creosote are highly combustible substances.

Thicker layers of these substances may catch

fire if the temperature in the flue increases sud-

denly. By allowing the fire to burn very

intensely regularly, layers of tar and creosote

will disappear.

Low intensity fires can also cause tar deposits

on the stove window and door.

When the outside temperature is mild, it is bet-

ter to burn wood intensely for a few hours

instead of having a low intensity fire for a long

period of time.

Control the air supply using the air vent.

The air inlet not only supplies air to the fire but

to the glass as well, so that it does not quickly

become dirty.

Open the primary air inlet for the time being if the air

supply by the secondary air inlet is inadequate or if

you want to fan the fire.

Topping up with a few logs regularly is better than

adding many logs in one go.

Extinguishing the fire

Do not add fuel and just let the fire go out. If a fire is

damped down by reducing the air supply, harmful sub-

stances will be released. For this reason, the fire

should be allowed to go out naturally. Keep an eye on

the fire until it has gone out. All air inlets can be closed

once the fire has died completely.

Removing ash

After wood has been burnt, a relatively small amount

of ash remains. This ash bed is a good insulating layer

for the stove base plate and improves combustion. It

is a good idea to leave a thin layer of ash on the stove

base plate.

The flow of air through the fire plate must not be

obstructed, however, and no ash may be allowed to

accumulate behind a cast-iron inner plate. Remove

the excess ash regularly.

Using the glove supplied, remove the ash pan and

empty it. Replace the ash pan and close the door.

Fog and mist

Fog and mist hinder the flow of flue gases through the

flue. Smoke can blow back and cause a stench. If it is

not strictly necessary, it is better not to use the stove

in foggy and misty weather.

Resolving problems

Refer to the appendix "Diagnostic diagram" to resolve

any problems in using the appliance.

Maintenance

Follow the maintenance instructions in this chapter to

keep the appliance in good condition.

Subject to change because of technical improvements

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dovre Brut Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info