Bedienungsanleitung Dovre TAI 45WT (Seite 42 von 187) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Norwegisch)

813290

Zoom out

Zoom in

Vorherige Seite

1/187

Nächste Seite

16 Subject to change because of technical improvements

The air inlet not only supplies air to the fire but

to the glass as well, so that it does not quickly

become dirty.

Open the primary air inlet for the time being if the air

supply by the secondary air inlet is inadequate or if

you want to fan the fire.

Topping up with a few logs regularly is better than

adding many logs in one go.

Extinguishing the fire

Do not add fuel and just let the fire go out. If a fire is

damped down by reducing the air supply, harmful sub-

stances will be released. For this reason, the fire

should be allowed to go out naturally. Keep an eye on

the fire until it has gone out. All air inlets can be closed

once the fire has died completely.

Fog and mist

Fog and mist hinder the flow of flue gases through the

flue. Smoke can blow back and cause a stench. If it is

not strictly necessary, it is better not to use the stove

in foggy and misty weather.

Resolving problems

Refer to the appendix "Diagnostic diagram" to resolve

any problems in using the appliance.

Maintenance

Follow the maintenance instructions in this chapter to

keep the appliance in good condition.

Flue

In many countries, you are required by law to have

your chimney checked and maintained.

At the start of the heating season: have the chim-

ney swept by a recognised chimney sweep.

During the heating season and after the chimney

has not been used for a long time: have the chim-

ney checked for soot.

At the end of the heating season: close off the chim-

ney and plug with newspaper.

Cleaning and other regularly

maintenance

Do not clean the appliance when it is still

warm.

Clean the exterior of the appliance with a dry lint-

free cloth.

You can clean the appliance interior thoroughly at the

end of the heating season:

If necessary, first remove the fire-resistant inner

plates. See the chapter "Installation" for instruc-

tions on removing and installing the inner plates.

If necessary, clean the air supply ducts.

Remove the baffle plate at the top of the appliance

and clean it.

Checking fire-resistant inner plates

The fire-resistant inner plates are consumables that

are subject to wear and tear. Inner plates are fragile.

Do not knock the inner plates with logs. Check the

fire-resistant inner plates frequently and replace them

when necessary.

See the chapter "Installation" for instructions on

removing and installing the inner plates.

The refractory inner plates may begin to show

hairline cracks, but this does not negatively

affect their functioning.

Never use the appliance without the fire-res-

istant inner plates.

Cleaning the glass

Dirt clings less easily to well-cleaned glass. Proceed

as follows:

1. Remove dust and loose soot with a dry cloth.

2. Clean the glass with stove glass cleaner:

a. Apply stove glass cleaner to a kitchen sponge,

rub down the entire glass surface and give the

cleaning agent time to react.

b. Remove the dirt with a moist cloth or kitchen

tissue.

3. Clean the glass again with a normal glass cleaning

product.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dovre TAI 45WT Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info