Bedienungsanleitung Dovre TAI 45WT (Seite 43 von 187) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Norwegisch)

813290

Zoom out

Zoom in

Vorherige Seite

1/187

Nächste Seite

Subject to change because of technical improvements 17

4. Rub the glass clean with a dry cloth or kitchen tis-

sue.

Do not use abrasive or aggressive products to

clean the glass.

Wear household gloves to protect your hands.

If the glass in the appliance is broken or

cracked, it must be replaced before you can

use appliance again.

Ensure that no stove glass cleaner runs

between the glass and the cast-iron door.

Enamelled stove maintenance

Never clean the appliance while it is still hot. The

most effective way to clean the enamelled surface of

the stove is with a mild green soap and lukewarm

water. Use as little water as possible, rub the surface

dry and prevent the formation of rust. Wire wool or

other abrasives should never be used. Never place a

kettle directly onto an enamelled stove; use a stand to

prevent damage. Attention: Do not allow aggressive

acidic products to get onto enamelled components.

Lubrication

Although cast-iron is slightly self-lubricating, you will

still need to lubricate moving parts frequently.

Lubricate the moving parts (such as guide sys-

tems,hinge pins, latches and air slides) with heat-

resistant grease that is available in the specialist

trade.

Touching up damaged paint

Small areas of damaged paint finish can be touched

up with a spray can of special heat-resistant paint,

available from your supplier.

Touching up the enamelled surface

Enamelling is a process carried out by traditional meth-

ods, meaning that it is possible that small colour dif-

ferences and damage may occur. The appliances

undergo a visual inspection in the factory, that is to

say, the inspector looks at the surface for a period of

10 seconds from a distance of 1 metre.

Any damage that does not stand out is regarded as

OK. A special heat-resistant paint is supplied with the

appliance to touch up any minor damage caused dur-

ing transport.

Apply the heat-resistant paint in thin layers and leave

to dry well before using the appliance.

Some enamel colours are temperature-sensitive. It

can happen that the colour changes during use.

The original colour will return after the appliance

has cooled down.

If enamelled surfaces become very hot, hairline

cracks can occur. This is a normal phenomenon

and has no impact on the functioning of the stove.

Ensure that the stove is not overburdened. If it

does become overburdened then the surface

gets very hot, possibly resulting in lasting dam-

age to the enamel.

Checking the seal

Check whether the door sealing rope is still in good

condition and works well. The sealing rope is sub-

ject to wear and will need to be replaced over time.

Check the appliance for air leaks. Close any

chinks with stove sealant.

Allow the sealant to harden fully before lighting

the appliance, as any moisture in the sealant

will form bubbles, resulting in a new air leak.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dovre TAI 45WT Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info