Bedienungsanleitung Drive ST4D 2G PLUS (Seite 22 von 72) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

801276

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Instructions for use ST4D 2G / ST4D 2G PLUS

Drive Medical GmbH & Co. KG | As per: 04.05.2020 | Errors and alterations excepted

Warning light

Press the warning light button once to switch on the

warning light system. Press the button again to switch

o the function. When the button is pressed, the warning

light function causes all indicators to blink and the horn

sounds.

Seat

The seat can be rotat-

ed 360° and snaps into

place in 45° increments.

To rotate the seat, pull

the lever (A) under the

left side of the seat up-

wards and then rotate

the seat. Release the le-

ver and continue rotat-

ing the seat until it snaps

into place.

You can adjust the space

for your feet on the electric scooter by pushing the seat

back and forth. To shift the seat, pull the handle for shift-

ing the seat (B) upwards.

Then place the seat in the proper position, release the

handle, and continue pushing the seat until it snaps into

place.

To change the angle of the backrest, pull the adjustment

lever (C), then adjust the backrest to the desired position

and release the lever.

Removing the seat: Pull lever A upwards and rotate the

seat approx. 10° to the left and lift it up.

Mounting the seat: Before putting the seat on again, pull

lever A upwards once again and put the seat fully on.

Then release lever A. After correct mounting, the seat

must once again snap into place in 45° increments.

Important: You must hear and feel the seat snap into

place.

Caution: Bring the seat back into the forward position

before you drive.

Adjusting the armrest

The height of the armrest which can be raised upwards

can be adjusted by rotating the adjustment wheel.

Adjusting the steering

column

The steering column can

be adjusted in various

positions:

• Press the lever on the

steering column down-

wards and move it in

the desired position.

• Release the lever

to lock the steering

column.

Neutral lever

The neutral lever enables a release of the automatic

brake so that the electric scooter can be pushed and/or

maneuvered by hand.

To allow the scooter to be moved, the scooter should be

switched o .

In neutral mode the brakes do not grip, therefore it should

not be used if:

1. Someone is sitting in the electric scooter

2. The electric scooter is left unattended

3. The electric scooter is on a slope

Driving mode/neutral

mode

Driving mode:

Move the lever to D: The

electric scooter is driven

by a motor.

Neutral mode:

Move the lever to N: The

electric scooter is in neu-

tral mode and can now

be pushed/moved by

hand.

Battery

Battery display

The battery charge status can be read on the control

panel. When the battery is fully charged, all segments of

the display are lit. The number of elements lit decreas-

es with the decreasing capacity of the battery. When the

battery display is lit to (F), this shows that the batteries

are fully charged.

When the battery display is lit to (E), this shows a low bat-

tery charge status and the batteries must be promptly

charged. This is signaled by a warning sound and the on/

o light blinks.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Drive ST4D 2G PLUS Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info