801276
25
Zoom out
Zoom in
Vorherige Seite
1/72
Nächste Seite
Instructions for use ST4D 2G / ST4D 2G PLUS
25
Drive Medical GmbH & Co. KG | As per: 04.05.2020 | Errors and alterations excepted
EN
Transport
Use a ramp to load the scooter. If necessary, you can
also lift the scooter over a step or the like. At least two
people are needed to do this. Lift the scooter only at
fixed parts of the frame, in the front and rear under the
cladding. For safety reasons, the scooter may be lifted
only WITHOUT the user.
Do NOT remain seated in your scooter when the scooter
is being transported in a vehicle. Always secure your
scooter and use a seat in the vehicle.
Exception: Taking your scooter with you in public trans-
port buses.
Storage
Ensure that the electric scooter is switched o and
stored with the battery removed and the charging unit
unplugged. Store the electric scooter in areas protected
from direct sunlight, water, and humidity.
Cleaning | Disinfection
Clean regularly with a moist cloth!
Do not use any aggressive cleaning agents!
Do not use abrasive cleaners!
Do not use any high-dose chlorine and vinegar-based
cleaners!
To disinfect, a spray disinfectant can be used such as
Descosept AF or Bacillol AF.
Check the screws regularly and tighten, if necessary.
The product must not be continuously exposed to
temperatures over 60°C.
In the event of defects, contact your specialist dealer
from whom you purchased this product.
Do not use any petroleum ether, solutions or evapo-
rating solutions since these could damage body parts.
Ensure that the charging unit was removed and that
the electric scooter is switched o before you clean it.
Do not park your electric scooter under wet or damp
conditions since this leads to mold growth and a rapid
deterioration of the cushioned parts.
Problem Cause Remedy
Electric scooter cannot
be switched on Batteries not connected
Circuit breaker/overload switch was triggered
Check battery connection
Press circuit breaker to reset
Electric scooter can be
switched on but does
not drive
Defective batteries
Charging unit is inserted
Motor is in neutral
Charge/replace battery
Remove charging unit from the electric
scooter
Put neutral lever into “Drive”
Electric scooter drives
slowly Weak batteries
Speed is set to low
Charge battery
Select higher speed
The seat moves during
operation The seat is not properly snapped into place Rotate the seat slowly until it snaps
into place and is secured (see section
entitled "Seat”).
The steering column
appears to be loose or
does not freely swivel
The fixing screws for the steering column are
loose
Tighten the fixing screws for the steering
column
Horn sounds
unintentionally or
automatically
The electric scooter has diagnosed an error Ensure that the control lever is not
operated and switch the electric scooter
o and on.
Charge the batteries if the problem
persists.
Troubleshooting
25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Drive ST4D 2G PLUS wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info