• The height of the pipe mouth is variable (max.690mm,
min.450 mm)
• Saw the plate for the outlet to the required length,as
shown in fig 3.
• Fix the outlet to the baffle using the mounting strips.
• TThe connection between the pipe mouth and the flue
duct should be made using corrosion-proof material.
• The connecting pipe should never be lower than the
heater pipe mouth.
• Fit a longer connecting pipe from the pipe mouth to the
flue sloping (2%) towards the pipe mouth.
Fitting the aluminium protective plate
The plate should be fitted under the foot of the interior
during installation.Slide the plate backwards until the front
is level with the front of the foremost adjustable feet.
Connecting to the gas supply
Use an approved connecting tap with coupling in the
supply pipe (for Belgium this must be B.G.V.approved).
In addition:
• Expel the air from the supply pipes before connecting
the appliance.
• Avoid pressure on the gas control block and the pipes.
• Check all connections for gas tightness.
Positioning the logs
• Open the glass window by unscrewing the two M6
socket-head screws on the right-hand side,using the
spanner provided.
• Fill the burner with vermiculite (this is in the plastic bag
with the log set).Spread it evenly over the burner tray
and the surrounding tray.Do not put any vermiculite
higher than the edge of the tray.Save the remaining
vermiculite in case you lose any later during cleaning or
maintenance.
Position the logs as follows:
• Lay the large log (A) against the back wall,on the log
supports,with the yellow side down and the knot
towards the left.
• Lay the front logs (B and C) with the bark facing up,as
illustrated in fig.4.
• The brown embers will create a glowing effect.Sprinkle
them sparingly on the burner.
(The embers are supplied in separate little bag).
• Now lay the rest of the logs (D,E,F,G and H) in place as
illustrated in fig.4.
• Close the window again with the two socket-head screws.
The logs should not be laid in any other way as this could
cause the formation of soot.Neither should the logs touch
pilot light burner.
You can "play" with the flames by moving the vermiculite,
embers and chips about on the burner bed until you have
created the desired flame effect.
English
Alto/Basso
INSTRUCTIONS FOR INSTALLATION
19
fig.4
D
A
D
B
G
E
F
H
C
