Bedienungsanleitung DRU Diablo Next (Seite 12 von 36) (Englisch)

571631

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

English

INSTALLATION MANUAL

5.9Additionalinstructions

!Tip

It will be easier to reach the gas control, if you remove the mantelpiece.

5.9.1Placingtheappliance

!Caution

• The temperature of the wall behind the appliance may rise up to 60°C. This should be taken into account

when selecting the wall and wall covering.

• A minimum free space of 100 mm space should be maintained below the appliance.

• At both sides and above the appliance, a free space of at least 500 mm should be maintained

(see Appendix 3, fig. 2.).

When placing the appliance, take the following aspects into account:

Firmly attach the wall plate (B) to a solid non combustible wall using four bolts (see Appendix 3, fig. 5A);

!Caution

The wall plate (B) must be level.

Carefully suspend the appliance (T) from the wall plate (B) (see Appendix 3, fig. 6).

5.9.2Gasconnection

Provide a gas connection (G3/8”) on the correct location (see Appendix 3, fig. 5B, 5C).

!Caution

Use for G20/G25/G25.3 fig. 5B and for G31 fig. 5C.

Make sure there is no dirt in gas pipes and connections;

• Connect the gas pipe to the gas tap.

• Bleed the gas pipe.

5.9.3Placingthereceiver

The appliance is equipped with an electronic ignition through the remote control. The receiver must be placed in

the appliance. Follow the procedure described below:

Place the receiver in the receiver tray (see Appendix 3, fig. 7).

Connect the receiver to the appliance according to the instructions in section 6.1.

5.10Glasspane

!Caution

• Avoid damages when removing/placing the glass pane.

• Avoid/remove fingerprints on the glass pane, as they will burn into the glass.

5.10.1Removingtheglasspane

For removing the glass pane, you must observe the following steps:

Remove the mantelpiece as indicated in section 5.13.

Fully remove the 4 self-tapping screws from the clamp strip and remove the clamp strip (see Appendix 3, fig. 8).

!Caution

Hold the glass pane to prevent it from falling out.

Now carefully remove the glass pane by tilting the top a little forward and lifting out the glass pane

(see Appendix 3, fig. 9).

!Caution

Make sure the sealing tape at the edges of the glass pane is not damaged during removal.

5.10.2Placingtheglasspane

Placing the glass pane will take place in reverse order of removing the glass pane, as described above.

!Caution

• Avoid/remove fingerprints on the glass pane, as they will burn into the glass.

• The bolts and nuts should not be over-tightened, since otherwise they could break or strip the thread:

tight=tight.

• Check whether the sealing tape is located neatly along the edge of the glass pane.

When placing back the glass pane, take the following instructions into account:

Slowly slide down the glass pane in its position and allow the glass pane to rest on the lower strip.

Make sure the glass pane is placed exactly in the middle of the appliance and neatly connects to the side panes.

!Caution

• Continue to stop the glass pane in the middle, so it does not fall back.

• Place the glass pane with the logo at the bottom right.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DRU Diablo Next Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DRU Diablo Next

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info