Bedienungsanleitung DRU GLOBAL 70 (Seite 31 von 60) (Englisch, Holländisch)

528137

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

English

INSTALLATION MANUAL

Global 70 / 70 XT

discharge/combustion air supply system, hereafter referred

to as the concentric system.

The passage to the outside can be made with a wall termi-

nal (see section 6.5.2) or a roof terminal (see section 6.5.3).

If necessary, you can also use an existing chimney (see

section 6.5.4).

- Only use the concentric system supplied

by DRU (Ø100 / Ø150 mm). This system

has been tested together with the ap-

pliance. DRU cannot guarantee a proper

and safe operation of other systems and

does not accept any liability for this;

- For connecting to an existing chimney

you should only use the chimney kit sup-

plied by DRU.

The concentric system is constructed from (the connection

stump of) the appliance.

If structural circumstances require that the concentric

system is placed ﬁ rst, the appliance can later be connected

with a telescopic pipe piece.

6.5.2 Application with wall terminal

6.5.2.1 Construction of concentric system with wall

terminal

The concentric system with wall terminal has to comply

with the following conditions:

- First, a concentric pipe of at least 1 meters should be

connected vertically to the appliance;

- The total vertical pipe length may have a maximum of

4 meters;

- A 90° bend is connected to the other end of the vertical

part;

- When using a minimum of 1 meter up to a maximum of

4 meters of vertical pipe length, the total horizontal pipe

length can have a maximum of 3 meters (excluding wall

terminal, see ﬁ g. 3a and ﬁ g. 3b).

Depending on the construction of the concentric system,

the appliance must receive further settings; see Table 1 for

determining the conditions and section 6.8, Adjusting the

appliance, for the method.

6.5.2.2 Placing concentric system with wall

terminal

- Maintain a distance of at least 50 mm

between the outside of the concentric

system and the walls and/or the ceiling.

If the system is built in (for instance) a

cove, it should be made with non com-

bustible material all around it.

- Use heat-resistant insulation material

when passing through combustible

material;

- The rosette (mounting inner plate) of

the wall terminal is too small to seal

the Ø 250 mm opening when passing

through combustible material. That is why

you should ﬁ rst apply a sufﬁ ciently large

heat-resistant intermediate plate to the

wall. Then, the rosette is mounted on the

intermediate plate.

!Caution Some heat-resistant insulation materials

contain volatile components that will

spread an unpleasant smell for a prolon-

ged time; these are not suitable.

Place the concentric system as follows:

• Build the system up from (the connection stump of) the

appliance.

• Connect the concentric pipe pieces and the bend.

• On each connection, apply a clip binding with silicon sea-

ling ring.

• Use a self-tapping screw to ﬁ x the clip binding to the pipe

on locations that cannot be reached after installation.

• Apply sufﬁ cient clamps, so that the weight of the pipes

does not rest on the appliance.

• Determine the remaining length of the wall terminal;

• Make sure the wall terminal has the right dimensions.

Caution

Table 1: Conditions for the adjustment of the appliance with a wall terminal

G20/25

Total Total number See Air inlet guide Bafﬂ e Distance

number of of meters ﬁ gure of

meters horizontal restriction

vertical pipe length in mm

pipe length (excluding

wall terminal)

1 - 4 >0 - 3 3a NO NO OPEN

1 - 4 0* 3b YES NO OPEN

* factory setting

Caution

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DRU GLOBAL 70 Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DRU GLOBAL 70

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info