Bedienungsanleitung Dyson V8 (Seite 13 von 20) (Englisch, Spanisch)

665103

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

WASHING THE BRUSH BARS

• Your machine has two washable brush bars, check and wash these regularly

according to the following instructions to maintain performance.

• Ensure the machine is disconnected from the charger before removing the brush

bar. Be careful not to pull the 'ON' trigger.

TO REMOVE, WASH AND REPLACE BRUSH BARS:

• Please refer to the 'Washing the brush bars' illustrations alongside the

instructions below.

• Turn the cleaner head upside down so the underside of the cleaner head is

facing you. Use a coin to turn the fastener one quarter counter-clockwise to the

unlocked position.

• Rotate the end cap to the open position. Gently slide the large brush bar away

from the cleaner head.

• Remove the end cap from the large brush bar.

• Lift out the small brush bar from the octagonal end and pull away from the

cleaner head.

• Hold the brush bars under running water and gently rub to remove any lint

or dirt.

• Stand both brush bars upright. Ensure the large brush bar is stood upright as

shown. Leave to dry completely for a minimum of 24 hours.

• Before replacing, check that the brush bars are completely dry. Refit the small

brush bar before the large one. Insert the round end of the small brush bar into

place. Push down the octagonal end until it clicks into place.

• Reattach the end cap to the brush bar.

• Slide the large brush bar back onto the cleaner head, around the motor. The

end cap should be in the open position as shown. Once in place, rotate the end

cap back into the closed position.

• Close the fastener by turning a quarter turn clockwise. Ensure that the fastener is

fully turned and the base plate and the brush bars are secure.

WASHING THE FILTERS

• Your machine has two washable filters; wash the filters at least once a month

according to the following instructions to maintain performance. More frequent

washing may be required where the user: vacuums fine dust, operates mainly in

“Powerful suction” mode, or uses the machine intensively.

WASHING FILTER A

• Ensure the machine is disconnected from the charger before removing the filter.

Be careful not to pull the “ON” trigger.

• Check and wash the filter regularly according to instructions to

maintain performance.

• The filter may require more frequent washing if vacuuming fine dust or if used

mainly in “POWERFUL SUCTION” mode.

• To remove the filter, lift it out of the top of the machine.

• Wash the filter with cold water only.

• Run water over the outside of the filter until the water runs clear.

• Squeeze and twist with both hands to make sure the excess water is removed.

• Lay the filter on its side to dry. Leave to dry completely for a minimum of

24 hours.

• Do not put the filter in a dishwasher, washing machine, tumble dryer, oven,

microwave or near an open flame.

• To refit, place the dry filter back into the top of the machine. Make sure it is

seated properly.

WASHING FILTER B

• To remove the filter, twist counter-clockwise to the open position and pull away

from the machine.

• Wash the inside of the filter under cold running water, rotating the filter to

ensure all pleats are covered.

• Gently tap the filter against the side of the sink several times to remove

any debris.

• Repeat this process 4-5 times until the filter is clean.

• Place the filter upright, with the MAX button facing upwards, and leave to dry

completely for a minimum of 24 hours.

• To refit, return the filter to the open position and twist clockwise until it clicks

into place.

BLOCKAGES – AUTOMATIC CUT-OUT

• This machine is fitted with an automatic cut-out.

• If any part becomes blocked the machine may automatically cut out.

• This will happen after the motor pulses a number of times (i.e switches on and

off in quick succession).

• Leave to cool down before looking for blockages.

• Ensure the machine is disconnected from the charger before looking for

blockages. Failure to do so could result in personal injury.

• Clear any blockage before restarting.

• Refit all parts securely before using.

• Clearing blockages is not covered by your warranty.

LOOKING FOR BLOCKAGES

The motor will pulse when there is a blockage. Please follow the instructions

below to locate the blockage:

• Ensure the machine is disconnected from the charger before looking for

blockages. Be careful not to pull the “ON” trigger.

• Do not operate while checking for blockages as doing so could result in

personal injury.

• Beware of sharp objects when checking for blockages.

• To check for blockages in the main body of the appliance, remove the clear

bin and cyclone as per the instructions in the cleaning the clear bin section and

remove the blockage. Please consult the 'Stubborn blockages' section of the

illustrations for further guidance.

• If you cannot clear an obstruction you may need to remove the brush bars,

please follow the instructions below:

– To remove the soft roller cleanerhead brush bars, please refer to the 'Washing

the soft roller cleanerhead brush bars' section. Remove the obstruction and

replace the brush bars as shown in the ‘Washing the soft roller cleanerhead

brush bars’ section. Ensure that the fastener is fully turned and the base plate

and brush bars are secure before operating the appliance.

– To remove the brush bars from the direct drive cleanerhead, use a coin to

unlock the fastener and slide the brush bars out of the cleanerhead. Remove

the obstruction. Replace the brush bar and secure it by tightening the fastener.

Ensure it is fixed firmly before operating the appliance.

• This machine has carbon fiber brushes. Take care if coming into contact with

them, as they may cause minor skin irritation. Wash your hands after handling

the brushes.

• Refit all parts securely before using.

• Clearing blockages is not covered by your warranty.

CHARGING AND STORING

• This machine will switch “OFF” if the battery temperature is below 37.4°F

(3°C). This is designed to protect the motor and battery. Do not charge the

machine and then move it to an area with a temperature below 37.4°F (3°C) for

storage purposes.

• To help prolong battery life, avoid recharging immediately after a full discharge.

Allow to cool for a few minutes.

• Avoid using the machine with the battery flush to a surface. This will help it run

cooler and prolong battery run time and life.

BATTERY SAFETY INSTRUCTIONS

• If the battery needs replacing please contact the Dyson Helpline.

• Use only Dyson chargers for charging this Dyson machine.

• The battery is a sealed unit and under normal circumstances poses no safety

concerns. In the unlikely event that liquid leaks from the battery do not touch the

liquid and observe the following precautions:

– Skin contact – can cause irritation. Wash with soap and water.

– Inhalation – can cause respiratory irritation. Expose to fresh air and seek medi-

cal advice.

– Eye contact – can cause irritation. Immediately flush eyes thoroughly with water

for at least 15minutes. Seek medical attention.

– Disposal – wear gloves to handle the battery and dispose of immediately, fol-

lowing local ordinances or regulations.

CAUTION

The battery used in this device may present a risk of fire or chemical burn if

mistreated. Do not disassemble, short contacts, heat above 140°F (60°C), or

incinerate. Keep away from children. Do not disassemble and do not dispose of

in fire.

DISPOSAL INFORMATION

• Dispose of or recycle the battery in accordance with local ordinances

or regulations.

• Keep the used batteries away from children as these can still harm children

if swallowed.

• Dyson products are made from high grade recyclable materials. Recycle

where possible.

• The battery should be removed from the product before disposal.

ONLINE SUPPORT

• For online help, general tips, videos and useful information about Dyson.

– www.dyson.com/SV10support

Dyson V8 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Dyson V8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info