Bedienungsanleitung Ecoforest Teide (Seite 31 von 152) (Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

742221

Zoom out

Zoom in

Vorherige Seite

1/152

Nächste Seite

2.12. FIRE IN THE EXHAUST. To prevent this situation from happening, observe the instructions set forth under

section 4 on how to install the gas outlet. What to do:

 The appliance will be turned off due to the excessive temperatures in the exhaust. Do not unplug the

stove.

 Call fire brigade.

 The stove must be tested by Chimeney’s sweeps after the soot fire, before it is reused

3. FUEL.

Your stove is designed to operate with wood pellets; however, it can also work with other biomass fuels (ask

your dealer about this). If using a different type of biomass is possible, select it from the fuel selection menu (check

user manual). In most cases, the combustion basket is not the same as for wooden pellets.

ECOFOREST do not have any control on the quality of the fuel you use. For this reason, ECOFOREST cannot

guarantee the full output of your stove nor the eventual premature aging or eventual damage of the gas outlet. The

fuel’s minimum requirements are specified below:

Pellets

Olive pits

Almond shells

Diameter (mm)

—

Length (mm)

—

Granulometry (mm)

—

Calorific value (Kcal/kg)

≥ 4300

≥ 3800

≥ 3700

Ash (% mass)

< 1.5

Humidity (%mass)

< 12

Oils

—

No oil

content

—

Burn pot and/or specific strangler.

Original

Specific

4. INSTALLATION.

The below security distances and assembly diagrams are given for information only as an adaptation shall be

made depending on the norms in force regarding gas outlet, power, security minimum distances specific to

geographic areas.

The installation of the stoves must be done in the same way, for this reason, only the ECOIII model will be

exposed. In the same way, air inlets and water connections will be missed in all drawings as section 4.19 indicates

the minimum security distances to be respected for their installation.

ELECTRICAL CONNECTION.

The power socket to which the stove is plugged should meet the following requirements:

4.1. Ground connection must comply with the specific applicable regulations.

4.2. Differential switch with the correct amperage. It must comply with the specific applicable regulations (check

technical specifications of the stove).

4.3. Single-phase AC of ~230/240V – 50Hz and pure sine wave.

4.4. The plug must only be connected to a socket with the technical characteristics of the plug in question.

4.5. Easily accessible power socket. If the power socket can’t be accessed due to the characteristics of the

electrical installation, an all-pole disconnection switch must be installed.

4.6. The power cable provided by ECOFOREST is 1.4m long; you might need a longer one. Always use a cable with

ground plug and with an equal or greater section. Make sure the power cable is not placed under the stove

or close to hot or sharp surfaces that could damage it.

UNPACKING THE STOVE.

4.7. Remove the packaging and the protective plastic.

4.8. Remove the screws

or bolts that fasten the stove to the pallet and remove it.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ecoforest Teide Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ecoforest Teide

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info