Bedienungsanleitung Edilkamin Demy (Seite 13 von 28) (Englisch)

810764

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

- 13 -

ENGLISH

INSTRUCTIONS FOR USE

PELLET OPERATION (LED RED)

Commissioning must be done by a Technical Service Centre

authorised by Edilkamin (CAT) prior to ignition and testing

according to the UNI 10683 standard.

This standard indicates the control operations to be carried out,

aimed at ascertaining correct system function.

The CAT will also provide for calibrating the stove on the

basis of the type of pellets and the installation conditions, thus

allowing for the effectiveness of the guarantee.

If the rst ignition is not carried out by a C.A.T. authorised by

Edilkamin, the guarantee shall not be effective.

For information, consult the website www.edilkamin.com

There may be a slight smell of paint the rst few times it is

ignited, however, this will disappear quickly.

Before igniting you must check:

• that installation is correct

• the power supply

• that the door closes properly to a perfect seal

• that the display is on standby (the date, power or temperature

ashes).

NOTE:

DURING pellet operation, you can load wood.

The stove automatically recognizes the change of fuel and

changes the operating mode from pellets to wood (The sta-

tus LED changes from RED to ashing GREEN/RED).

FILLING THE PELLET HOPPER

Open the two doors A and B to access the hopper (Fig. 1).

N.B.

1) During this operation, the bag of pellets MUST NEVER

be placed on the upper grill, otherwise the plastic bag,

coming into contact with the heat, could ruin the paintwork

on the top.

2) Use the special glove provided if you load the stove while

it is functioning and therefore hot.

maximum moisture content: 8%

caloric value: at least 4100 kcal/kg.

If pellets with different characteristics are used, the stoves

must be recalibrated using a similar procedure to that carried

out by the DEALER when the stove is ignited the rst time.

Using unsuitable pellets may: decrease efciency; cause

malfunctions; stop the stove from functioning due to clogging,

dirt on the glass, unburnt fuel, etc.

A simple, visual analysis of the pellets may be carried out:

Good quality: smooth, uniform length, not very dusty.

Poor quality: with longitudinal and transverse cracks, very

dusty, various lengths and mixed with foreign matter.

NOTE regarding the fuel: pellet.

DEMY is designed and programmed to burn wood pellets with

6 mm diameter.

Pellets are a type of fuel in the form of little cylinders, made

from compacted sawdust, compressed under high pressure

with no adhesives or foreign materials.

They are sold in bags of 15 kg.

For the stove to function properly, you MUST NOT burn

anything else in it.

Such use is detected by laboratory analyses. Edilkamin has

designed, tested and programmed their stoves to guarantee the

best performance when pellets with the following characteri-

stics are used:

diameter: 6 millimetres

maximum length: 40 mm

FRONT HOT AIR DEFLECTOR

It’s possible to ow hot air from the front using the deector

supplied.

Install the deector in the rear part of the stove (g.1/a) using 4

screws already installed on the structure frame.

g. 1

g. 1/a

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin Demy Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Edilkamin Demy

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info