Bedienungsanleitung Edilkamin Meg (Seite 30 von 178) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch)

810916

Zoom out

Zoom in

Vorherige Seite

1/178

Nächste Seite

- 30 -

ENGLISH

Pump (circulator)

“Pushes” water toward the heating system.

Closed expansion tank

“absorbs” the variations in the volume of water contained insi-

de the boiler-stove due to the heating effect.

Aheating technician must evaluate the need to add a second

tank to the existing one, depending on total amount of wa-

ter in the system.

Gear motor

This activates the screw allowing the transport of the pellets

from the hopper to the chamber.

Manometer

Positioned on the back of the thermo stove

(B -ﬁ g. 1), it allows

water pressure to be read. When the thermo stove is running,

the recommended pressure is 1,5 bar.

Drain tap

Positioned on the back of the thermo stove, low down. It must be

opened if the water the unit contains needs to be drained.

Venting valve

Positioned in the upper part under the front-top grill (see page

36 ﬁ g. 2), it allows for any air present during the loading of the

water into the stove to be bled off.

Smoke thermocouple

on the smoke outlet. It reads the smoke temperature. It regula-

tes the ignition stage and shuts the boiler-ﬁ replace down if the

temperature is too high or too low.

Flow sensor

located in the extraction duct, is activated and shuts down the

thermo stove when the ﬂ ow of combustion air is incorrect,

which means a resulting risk of low pressure problems in the

smoke circuit.

Feed Screw safety thermostat

Placed near the pellet hopper. It disconnects the electrical sup-

ply to the gear motor if the temperature detected is too high.

Water temperature detector

It reads the water temperature in the boiler and sends the circuit

board information for pump management and boiler power

modulation.

If the temperature is too high, it starts a shutdown.

Water overheating safety thermostat

detects the water temperature in the thermo-stoves. If this is

too high, it triggers the shutdown process by disconnecting the

electrical supply to the gear motor. If the thermostat has trigge-

red a reaction, it must be reset by means of the red emergency

button at the back of the stove (A - ﬁ g. 1).

Overpressure valve 3 bar

Upon reaching the pressure stipulated on the plate, the system

is triggered to discharge the water and consequently the water

must be topped up.

WARNING!!!! remember to carry out the connection with

the sewage system.

Electric coil

It sets off of the combustion of the pellets and it remains lit until

the ﬂ ame has been ignited. This component is subject to wear.

Pressure switch

Positioned in the fume-aspiration area, it is triggered in the case

of a depression in the fumes circuit (e.g. obstructed ﬂ ue) and

interrupts the movement of the pellets. It blocks pellet loading

causing the stove to go out.

Vacuum gauge (electronic pressure sensor):

positioned on the smoke extractor, which detects the vacuum

value (compared to the installation environment) in the combu-

stion chamber.

Tank safety thermostat:

Located on the system that loads the pellets from the hopper.

Trips when the temperature inside the boiler-stove is too high.

It stops pellet loading, causing the boiler-stove to go out.

FEATURES

• COMPONENTS - SAFETY AND DETECTION DEVICES

N.B.:

IF THE BOILER-STOVE BLOCKS, THE REASON WILL APPEAR ON THE DISPLAY AND THIS WILL BE SAVED.

ﬁ g. 1

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin Meg Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info