Bedienungsanleitung Edilkamin Mito Idro (Seite 13 von 32) (Englisch)

810921

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

ENGLISH

maschio 1/2"

Ø 8 cm

uscita fumi

Ø 4 cm aria

combustione

110

18,5

1,5

879,5

maschio 3/4"

maschio 1/2"

Ø 8 cm

uscita fumi

Ø 4 cm aria

combustione

110

18,5

1,5

879,5

maschio 3/4"

TYPICAL EXAMPLES

Fig. 1 Fig. 2

A: insulated steel chimney flu, Insulated

B: minimum height 1.5 m, and however

beyond the eaves of the roof

C-E: air intake from outside (through

section at least 80 cm²)

D: steel chimney flue inside existing ma-

sonry chimney flue

INSTALLATION

FLUE SYSTEM(Smoke duct, flue and

chimney pot)

This chapter has been drawn up pursuant to European

standards EN 13384, EN 1443, EN 1856 and EN 1457.

The installer must observe both these and any other

local regulations. This manual does not in any way

substitute such regulations.

The product must be connected to a flue system which

ensures that the smoke produced by combustion is

discharged in complete safety.

Before positioning the appliance, the installer must

check that the flue is suitable.

SMOKE DUCT, FLUE

The smoke duct (which connects the smoke outlet of

the combustion chamber with the flue) and the flue

itself must, among other regulatory requirements:

• receive the smoke from a single product (outlets

from multiple appliances may not be conveyed

into a single flue)

• be routed vertically for the most part

• have no downwards sloping sections

• preferably have a circular internal cross section, or

with a ratio of the sides of less than 1.5

• terminate at roof level with a proper chimney pot:

the flue may not discharge directly onto the wall

or into an enclosed space, even if the space in

question is open to the sky

• be made of material with rated fire reaction class

A1 as per UNI EN 13501 or analogous national

regulations

• be certified, with a chimney plate if metal

• be of uniform cross section or vary in cross section

only immediately after the outlet, not at some mid

point of its length

THE SMOKE DUCT

Further to the general prescriptions for the smoke duct

and flue, the smoke duct:

• may not be made of flexible metal material

• must be insulated, if routed through unheated

areas or outdoors

• must not be routed through rooms where the

installation of combustion heat generators is

prohibited, where there is risk of fire, or which

cannot be inspected

• must enable the recovery of soot and be open for

inspection

• must have at most 3 bends with a maximum angle

of 90°

• if there is a horizontal section, it must be a single

one with a maximum length of no more than 3

metres, depending on the draw. Note, in any case,

that long sections promote the accumulation of

dirt and are harder to keep clean.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin Mito Idro Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Edilkamin Mito Idro

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info