Bedienungsanleitung Edilkamin Mito Idro (Seite 16 von 32) (Englisch)

810921

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

ENGLISH

- Must have a vertical expansion of not less than 30 cm.

After which the pipe can continue horizontally with a

gradient that fosters the flow of water.

- The diameter of the pipe must be at least one mea-

surement larger than the nominal measurement of the

discharge of the valve.

The end of the pipe must discharge into the sewer

system.

IT IS FORBIDDEN TO SHUT OFF THE DI-

SCHARGE

• Verify that the hydraulic system is correctly installed

and is equipped with an expansion tank that is sufficien-

tly large to guarantee safety.

The presence of a tank within the boiler-

stove does NOT guarantee appropriate pro-

tection from thermal expansion occurring in

the whole system.

Therefore the installer must assess whether

an additional expansion tank is needed, de-

pending on the type of system installed.

• Fill the system using the filling tap (it is recommended

not to exceed a pressure of 1,5 bar).

When filling, ‘bleed’ the pump and the relief tap.

• It is possible that it will be necessary to open the vent

(V - fig. 2)

during the initial days of operation to release

air in the system.

PLUMBING CONNECTION

The plumbing connection depends on the type of system.

However, there are some “common rules”:

• The plumbing connection must be carried out by qua-

lified personnel who can issue documentation declaring

correct installation conforming to current law in each

country (for example, in Italy according to Ministerial De-

cree 37/2008 and standard UNI 10412-2)

• The plumbing system must operate at a pressure

between 1 and 1.5-2 bar on a hot closed-vessel circuit.

Note: DO NOT install the stove in place of, for example,

a thermocooker installed with an open vessel without an

adequate expansion system making it a closed vessel.

• The separation of the primary from the secondary cir-

cuit is ideal and, in some countries, it is also mandatory

in case of the installation of a heating plant (for example,

in Italy, the reference is the Circular from ISPESL, now

INAIL, of April 2011).

This separation is easily carried out using KIT A2 from

Edilkamin.

• The presence of a puffer (inertial storage tank) is re-

commended but not mandatory. Its presence has the

advantage of freeing the stove from “sudden” demands

from the heating system and allowing the integration of

other heat sources. It reduces consumption and increa-

ses the efficiency of the system.

• The hot water exiting from the output of the stove must

be “directed” differently depending on the objective (hea-

ting, radiators, exchanger, whether or not there is a puffer,

etc.)

• The return temperature of the water at the stove must

be at least 50-55°C to avoid condensation. Depending on

the system, the installer must determine if anti-condensa-

tion valves or pumps are necessary.

• A puffer (inertial storage tank) is needed for heating

any installed low-temperature under-floor heating panels

according to the guidelines of the manufacturer of the

panels. The under-floor panels should not receive water

directly from the stove.

• The material used in the circuit must be suitable to

withstand any overheating.

• The discharge of the safety valve must be accessible

and visible.

The discharge water must be channelled into a vertical

pipe using a funnel with backflow air intakes, appropria-

tely spaced from the discharge point.

The conveying pipe must have the following characteri-

stics:

- Must not originate more than 50 cm from the discharge

of the valve and must be positioned in the same room

where the KIT is positioned.

INSTALLATION

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Edilkamin Mito Idro Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Edilkamin Mito Idro

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info